WASHER LEAKS OR DRAINS POORLY BECAUSE THE DRAIN HOSE IS DAMAGED, KINKED, OR INCORRECTLY POSITIONED
Samsung Washer Drain Hose DC67-00244L, Fixes Washer leaks or drains poorly because the drain hose is damaged, kinked, or incorrectly positioned
Samsung HOSE-DRAIN; HEBA, EPDM, ID6, T2, black.
Part DC67-00244LSamsung
Samsung HOSE-DRAIN; HEBA, EPDM, ID6, T2, black.
Is This the Right Part?
Part NumberDC67-00244L
ManufacturerSamsung
Appliance TypeWasher
Part TypeDrain Hose
Common Symptoms
- Water leaking from the hose or its connections
- Washer drains slowly or does not drain
- Siphoning or abnormal draining caused by incorrect hose insertion, height, or an airtight connection
- Hose slipping from the standpipe or sink and spilling water
Check Before Replacing
- With the washer unplugged and accessible, visually inspect the entire hose and both connections for cracks, rubbing damage, looseness, kinks, or pinching.
- Confirm the hose is inserted approximately 6–8 inches into the standpipe or sink, is secured against slipping, and does not form an airtight connection.
- Verify the hose routing and height: approximately 18–96 inches for a standpipe, or 24–35 inches for a sink, following the washer's installation instructions.
- Run the washer's drain check or a drain portion of a cycle only after confirming the hose is safely routed; observe whether water exits normally and check for visible leakage.
- If the washer still does not drain after the hose checks, do not assume the hose is defective; the pump, filter, or household drain may also require service.
Pro Tip
Do not push the hose more than 8 inches into the drain or create an airtight seal; either condition can cause siphoning and drain-related problems.
Part Details
Part NumberDC67-00244L
Part TypeDrain Hose
ManufacturerSamsung
Appliance TypeWasher
Primary FunctionRoutes wastewater from the Samsung washer to the household drain.
Key Features
- Genuine Samsung HOSE-DRAIN component
- Black EPDM construction
- Samsung specification identifies HEBA hose design with approximately 6 mm inside diameter and 10 mm outside diameter
- Designed for compatible Samsung washing machines
Installation Notes
- Disconnect electrical power before accessing or replacing the hose, and follow the washer's service or installation documentation.
- Route the replacement hose smoothly without sharp bends, pinching, or contact that could cause rubbing damage.
- Secure the drain end so it cannot slip farther into the standpipe or fall out.
- Maintain the manufacturer's specified insertion depth and drain height; do not create an airtight connection.
- Do not remove the rear hose holder or retaining hardware unless the applicable service instructions specifically require it.
Verified Compatible Models
WW22K6800AW/A2, WW22K6800AW/A2-00, WW22K6800AX/A2
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
