Samsung Washer Drain Hose DC67-00244L

Is This the Right Part?

Common Symptoms

• Water leaking from the hose or its connections
• Washer drains slowly or does not drain
• Siphoning or abnormal draining caused by incorrect hose insertion, height, or an airtight connection
• Hose slipping from the standpipe or sink and spilling water

Check Before Replacing

• With the washer unplugged and accessible, visually inspect the entire hose and both connections for cracks, rubbing damage, looseness, kinks, or pinching.
• Confirm the hose is inserted approximately 6–8 inches into the standpipe or sink, is secured against slipping, and does not form an airtight connection.
• Verify the hose routing and height: approximately 18–96 inches for a standpipe, or 24–35 inches for a sink, following the washer's installation instructions.
• Run the washer's drain check or a drain portion of a cycle only after confirming the hose is safely routed; observe whether water exits normally and check for visible leakage.
• If the washer still does not drain after the hose checks, do not assume the hose is defective; the pump, filter, or household drain may also require service.

Pro Tip

Part Details

Installation Notes

• Disconnect electrical power before accessing or replacing the hose, and follow the washer's service or installation documentation.
• Route the replacement hose smoothly without sharp bends, pinching, or contact that could cause rubbing damage.
• Secure the drain end so it cannot slip farther into the standpipe or fall out.
• Maintain the manufacturer's specified insertion depth and drain height; do not create an airtight connection.
• Do not remove the rear hose holder or retaining hardware unless the applicable service instructions specifically require it.

Verified Compatible Models

WW22K6800AW/A2, WW22K6800AW/A2-00, WW22K6800AX/A2

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.