Samsung Washer Not Filling with Water? Inlet Valve DC97-15459G – Fix No-Fill Fast
If your Samsung washer won’t fill with water, fills too slowly, or keeps filling without stopping, the water inlet valve is the most likely cause. In most Samsung front-load and top-load washers, the inlet valve controls the flow of hot and cold water into the tub during each cycle — when the solenoid coils fail or the valve body cracks, water flow stops entirely, becomes restricted, or the valve sticks open and the machine overfills. ⚡ Common failure point in Samsung-built washers. Part DC97-15459G is the genuine OEM replacement that restores correct water flow and fill control immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Washer powers on and control panel responds normally
- ✔ Water supply hoses are connected, valves are open, and water pressure is confirmed adequate
- ✔ Drain pump and motor are confirmed working
- ✔ Solenoid coils on the existing valve test open or shorted with a multimeter
- ✔ ONLY problem is washer won’t fill, fills slowly, or overfills without stopping
Not sure? Send us your model number — we’ll confirm before you order.
🔧 Common Symptoms
- Washer won’t fill with water — cycle starts but tub stays empty
- Washer fills very slowly — restricted flow through failed solenoid
- Washer overfills or won’t stop filling — valve stuck open
- Water leaking from the rear of the washer — valve body cracked or fitting failed
- Humming noise at the start of the cycle but no water enters the tub
- Washer stops mid-cycle with a water supply error code (e.g. 4E, 4C)
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this inlet valve restores correct fill operation immediately.
📦 Part Details
- Part Number: DC97-15459G
- Type: Washer Water Inlet Valve — dual solenoid, hot and cold water ports
- Fit: OEM direct-fit replacement (no modification required)
- Brands: Samsung front-load and top-load washing machines
While the inlet valve is out, inspect the fill hose screens (inlet filters) for sediment buildup — clogged screens restrict flow and can cause a new valve to fail prematurely. Clean or replace the screens at the same time for a complete repair.
⚙️ Installation
Skill Level: Easy — 20–40 minutes. Disconnect power and shut off the water supply before beginning. Pull the washer away from the wall and remove the rear access panel to expose the inlet valve. Disconnect the wiring harness and water hoses, remove the mounting screws, and install the new valve in reverse order. Reconnect hoses, restore water and power, and run a fill cycle to confirm correct operation before pushing the washer back into position.
✓ Compatible Models
Confirmed compatible with Samsung front-load and top-load washer models using the DC97-15459G water inlet valve. Contact us to verify your model number before ordering.
💡 Pro Tip
A multimeter test on the inlet valve solenoid coils takes 2 minutes and confirms the valve is the root cause before you spend money on parts. Set your meter to resistance (ohms) and probe each solenoid terminal pair — a good coil reads 200–500Ω, an open or shorted coil reads OL or 0Ω and confirms valve failure. This also rules out a wiring harness issue before you replace the valve.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
