DE96-01050A Oven Control Board – Oven Won’t Heat or Hold Temperature? This Board Is the Cause
Is This the Part You Need?
If your Samsung range oven won’t heat, displays temperature error codes, or fails to maintain the set temperature, the oven control board is the primary suspect. Part DE96-01050A is the genuine OEM control board for Samsung slide-in ranges, superseding legacy numbers AP5272958, 1482822, AH3650910, EA3650910, and PS3650910. It installs directly with no modifications and restores full oven function — temperature regulation, bake and broil element control, and display operation.
Symptoms This Part Fixes
- Oven not heating at all — bake or broil elements not activating
- Oven not reaching or maintaining set temperature
- Temperature error codes on the display (e.g. SE, E-08, tE)
- Oven display blank, flickering, or showing incorrect readings
- Oven shutting off mid-cycle unexpectedly
- Broil element working but bake element not (or vice versa)
- Control panel buttons unresponsive or erratic
- Range completely dead — no display, no response
Part Details
- OEM Part Number: DE96-01050A
- Supersedes: AP5272958, 1482822, AH3650910, EA3650910, PS3650910
- Part Type: Range Oven Control Board / Main PCB Assembly
- Compatible Brands: Samsung (verify by model number)
- Fit: Direct OEM replacement — no modification required
- Repair Difficulty: Intermediate (3/5)
Installation Notes
- Skill Level: Intermediate — rear panel or control console access required
- Disconnect power at the wall outlet or breaker before starting — control boards carry live voltage
- The control board is typically located behind the rear control panel or inside the console — consult your model’s service diagram to confirm location
- Photograph all wire harness connections before disconnecting — label connectors if needed
- Reconnect all harnesses firmly and verify each connector is fully seated before reassembly
- Restore power and run a test cycle to confirm oven heating and display operation
- If error codes persist after installation, perform a hard reset: disconnect power for 5 minutes, then restore
Compatible Models
FE710DRS/XAA, FE710DRS/XAC, FE710DRS/XAA-01, FE710DRSG/XAA. Contact us to confirm your model.
A faulty oven temperature sensor (probe) sends bad readings to the control board and causes identical symptoms — oven not heating, wrong temps, and error codes. Before replacing the board, test the sensor resistance with a multimeter (typically around 1080 ohms at room temperature for Samsung ranges). If the sensor is out of spec, replace it first — it’s a fraction of the cost. If the sensor checks out, the control board is your next step.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
