Oven Not Igniting? Hot Surface Igniter DG94-01012A – Fix No-Bake Fast

A failed hot surface igniter is the most common reason a Samsung gas oven won't heat, even when the burners light normally. In most Samsung ranges, the bake igniter weakens over time and eventually draws insufficient current to open the gas valve. When it fails, the oven won't reach temperature, baking cycles abort, or the oven simply won't light at all. ⚡ Leading failure point in Samsung NX-series gas ranges. Part DG94-01012A is the genuine OEM replacement that restores full ignition current and gets your oven baking reliably again.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ The range powers on and surface burners ignite normally
• ✔ The broil element or broil burner functions correctly
• ✔ Gas supply to the range is confirmed on and at correct pressure
• ✔ The oven control board shows no fault codes related to the control circuit
• ✔ ONLY problem is the oven not heating, not igniting, or cutting out before reaching temperature

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Oven won't heat up — most common, burner never lights during bake cycle
• Oven takes extremely long to preheat then shuts off
• Igniter glows orange but oven never ignites (weak igniter — classic sign)
• Oven starts then cuts out mid-cycle
• Baked goods consistently undercooked despite correct temperature setting
• Oven works on broil but not bake

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this hot surface igniter restores normal bake operation immediately.

📦 Part Details

• Part Number: DG94-01012A
• Type: Hot Surface Igniter Assembly — Bake Burner
• Replaces: OEM direct-fit igniter assembly — supersedes SGR1012A, 41-229 (no modification required)
• Brands: Samsung

⚙️ Installation

Skill Level: MODERATE — 30–45 minutes. Disconnect power and shut off the gas supply before beginning. Remove the oven racks and bottom panel to access the bake burner assembly; disconnect the igniter wire harness, remove the two mounting screws, and swap in the new igniter. Do not touch the igniter element with bare hands — skin oils can create hot spots that shorten its lifespan; handle by the ceramic base only.

✓ Compatible Models

Confirmed compatible with NX58J7750SS/AA, NX58J7750SS/AC, NX58K9500WG/AA, NX58K9500WG/AC, NX58H9500WS/AA, NX58M6650WS/AA, NX58M6850SS/AA, NX58K9850SS/AA, NX58M6650WG/AA, NX58K9850SG/AA, NX58M6850SG/AA, NX58K7850SG/AA, NX58K7850SS/AA, NX58M6630SS/AA, NX58M6630SG/AA, NX58K3310SW/AA, NX58K3310SS/AA, NX58M9960PS/AA, NX58M9960PM/AA, NX58K3310SB/AA, NX58M9420SS/AA, NX58H9500WS/AC, NX58H9950WS/AA, NX58J7750SG/AA, NX58N9420SG/AA, NX58R9421SS/AA, plus additional Samsung NX-series models. Contact us to verify your model number before ordering.

💡 Pro Tip