WATER LEAKING FROM THE BOTTOM OF THE DISHWASHER DOOR
Bosch Dishwasher Seal-door 00744884, Fixes Water leaking from the bottom of the dishwasher door
Bosch lower dishwasher door seal assembly with trough clips.
Part 00744884Bosch
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part Number00744884
ManufacturerBosch
Appliance TypeDishwasher
Part TypeSeal-door
✅ Cross Reference Information
Current Part Number00744884
Common Symptoms
- Water leaking from the lower door area
- Door not sealing evenly because of gaps, tears, or cuts
- Door may not latch properly when the seal interferes with closure
Check Before Replacing
- Inspect the seal for tears, cuts, gaps, deformation, or deterioration.
- Check whether the seal contacts the mating surface evenly around the door.
- Close the door on a dollar bill at several points; weak or absent resistance can indicate a sealing gap.
- If the seal appears intact, inspect for hinge or door-alignment issues before replacing it.
Pro Tip
Keep the dishwasher door closed for several hours after installation so the replacement seal can properly seat.
Part Details
Part Number00744884
Part TypeSeal-door
ManufacturerBosch
Appliance TypeDishwasher
Primary FunctionSeals the gap between the dishwasher door and tub to help prevent water leakage.
Installation Notes
- Disconnect electrical power before servicing the dishwasher.
- Verify the complete dishwasher E-Nr./model number before ordering.
- After installation, keep the door closed for several hours to allow the seal to seat properly.
Verified Compatible Models
Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
All brand names are the property of their respective owners and are used for compatibility reference only.
