LG Dryer Won’t Start, Has No Power, or Stops Mid-Cycle? Control Board EBR31002613 – Fix Electronic Failures Fast

If your LG dryer won’t power on, shows a blank display, stops mid-cycle without completing, or throws persistent error codes that won’t clear, the main control board is the most likely failed component. In most LG dryers, the main control board is the central processing unit that manages every electronic function — cycle selection, motor control, heating element activation, sensor inputs, and the display panel. When it fails, the dryer may go completely dead, behave erratically, or stop responding to button inputs entirely, leaving laundry wet and the machine unusable. ⚡ Common failure point in LG DLE-series dryers after power surges, moisture exposure, or age-related component degradation. Part EBR31002613 is the genuine OEM replacement control board that restores full factory electronic function — no programming or calibration required after installation.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Power supply confirmed OK — outlet is live, circuit breaker is not tripped, power cord is undamaged
• ✔ Door switch is functional — dryer door closes and latches properly
• ✔ Thermal fuse and thermostats have been tested and are not blown
• ✔ ONLY problem is the dryer won’t start, has no display, stops mid-cycle, or shows error codes that persist after a power reset

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Dryer completely dead — no power, no display, no response to any button
• Dryer starts but stops mid-cycle before clothes are dry
• Display panel blank or showing error codes that won’t clear after a power reset
• Buttons unresponsive or behaving erratically — wrong cycles selected or settings not saving
• Dryer runs but won’t heat despite heating element and thermostats testing good
• Dryer stuck in one cycle and won’t advance or complete

✔ If these symptoms match, the control board is the most likely failed component in the system.

✔ In most cases, replacing the EBR31002613 restores full dryer function immediately with no additional configuration.

📦 Part Details

• Part Number: EBR31002613
• Type: Main Control Board / Electronic Control Board Assembly — Genuine OEM LG
• Replaces: EBR85130501
• Brands: LG
• Appliance Type: Electric Dryer (DLE series)
• Programming Required: None — direct plug-in replacement, factory-configured

⚙️ Installation

Skill Level: Moderate — 30 to 45 minutes. Disconnect power before servicing. The control board is located behind the control panel at the top of the dryer. Remove the screws securing the control panel, photograph all wire harness connector positions before disconnecting, then transfer each connector to the new EBR31002613 board in the same positions. Secure the board, reassemble the control panel, restore power, and run a test cycle to confirm full operation.

✓ Compatible Models

Confirmed compatible with DLE7000W, DLE7100W, DLE7150W. Contact us to verify your model number before ordering.

💡 Pro Tip