LG Washer Display Blank or Showing Wrong Info? Display Board EBR32268107 – Fix Washer Display Faults Fast

If your LG washer display is blank, flickering, showing incorrect cycle information, or the control panel is unresponsive, the display board assembly is the most likely cause. In most LG front-load washers, the display board drives the user interface — cycle selection, status readout, error codes, and button inputs all route through this board. When it fails, the washer may appear dead, show garbled characters, or refuse to accept cycle inputs even though the main control board is functioning normally. ⚡ Common failure point in LG-built front-load washers. Part EBR32268107 is the genuine OEM display board assembly — direct fit for compatible models, no programming required.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer has power — outlet and power cord confirmed OK
• ✔ Washer runs cycles (even if display is blank or incorrect)
• ✔ Main control board has been ruled out as the fault source
• ✔ Wiring harness between display and main board is confirmed intact
• ✔ ONLY problem is a blank, flickering, or unresponsive display panel

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Washer display completely blank — no lights or characters visible
• Display flickering or showing garbled / partial characters
• Cycle selection buttons unresponsive or intermittently working
• Washer runs but selected cycle or time remaining won’t display
• Error codes appearing on display that clear when board is replaced
• Display works intermittently — comes on and off randomly

✔ If these symptoms match, the display board is the most likely failed component.

✔ In most cases, replacing this board restores full display and button functionality immediately.

📦 Part Details

• Part Number: EBR32268107
• Type: Washer Display Board Assembly (User Interface Board)
• Replaces: OEM direct-fit display board — supersedes EBR32268107 (current OEM number; confirm model compatibility before ordering)
• Brands: LG
• Weight: 10 lbs
• Options: Available as OEM new or Certified Pre-Owned (used)

⚙️ Installation

Skill Level: Moderate — 20–30 minutes. Disconnect power before beginning. Remove the top panel or control panel housing to access the display board, photograph all harness and ribbon cable connections before disconnecting, then swap the board and reconnect all cables fully. Power on and confirm display function before reassembling the housing.

💡 Pro Tip

Compatible model hub pages: F1267FDC, F1282FDC, WM2140CW