Menu
Genuine OEM Replacement Part
5304504077 Frigidaire Dishwasher Pressure Sensor Switch – Fix Overfill, Incomplete Fill, or Erratic Cycles
OEM Frigidaire / Electrolux | Controls Water Level Detection | New & Used Options
✔ OEM Frigidaire Part
✔ Restores Accurate Fill Levels
✔ Prevents Overfill & Overflow
✔ New & Used Options
If your Frigidaire dishwasher is overfilling, not filling to the right level, stopping mid-cycle, or running erratic wash sequences — the pressure sensor switch is one of the most likely causes. The 5304504077 is the OEM replacement that restores accurate water level detection and gets your dishwasher cycling correctly again.
What This Part Does
The pressure sensor switch monitors water pressure inside the dishwasher tub as it fills. When the water reaches the correct level, the pressure change triggers the switch, signalling the control board to stop filling and advance to the wash cycle. A failed switch causes the dishwasher to overfill, underfill, or lose track of where it is in the cycle entirely.
Part Details
- Part Number: 5304504077
- Brand: Frigidaire / Electrolux (OEM)
- Weight: 5 lbs
- Available Conditions: New, Used
Symptoms This Part Fixes
- Dishwasher overfills or water level is too high
- Dishwasher doesn’t fill enough before starting the wash
- Cycle stops or pauses unexpectedly mid-wash
- Erratic cycle behaviour or incorrect cycle sequencing
- Premature drain before washing is complete
- Error codes related to water level or fill detection
Compatible Models
Fits select Frigidaire and Electrolux dishwasher models. Contact us with your model number to confirm compatibility before ordering.
Installation
Disconnect power before servicing. The pressure sensor switch is typically located behind the lower access panel near the sump area. Disconnect the wiring harness and pressure hose from the old switch, install the new switch in the same position, reconnect the harness and hose, and reassemble. Run a test cycle to confirm correct fill level and cycle progression.
Pro Tip
Before replacing the pressure sensor switch, check the small rubber pressure hose that connects the switch to the sump — a cracked, kinked, or disconnected hose is a common cause of pressure sensing failure and is a free fix. Also inspect the hose for mineral buildup that can block the pressure signal. If the hose is clear and intact, then the switch itself has failed and needs replacement.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
