GE WD21X24901C Dishwasher Machine Control Board – Dishwasher Won't Start or Cycles Won't Complete (NLA – Limited Stock)
GE WD21X24901C Dishwasher Machine Control Board – Dishwasher Won't Start or Cycles Won't Complete (NLA – Limited Stock)

GE WD21X24901C Dishwasher Machine Control Board – Dishwasher Won't Start or Cycles Won't Complete (NLA – Limited Stock)

Sale price
$173.25
Regular price
$207.90
You save
$34.65 (17%)

Frequently Bought Together

Confirm This Fits Your Model
Not sure where to find your model number? See guide →
GENUINE OEM REPLACEMENT PART

GE WD21X24901C Dishwasher Machine Control Board – Dishwasher Won't Start or Cycles Won't Complete (NLA – Limited Stock)

⚠️ This part is No Longer Available (NLA) from GE. We may have limited units remaining on hand — contact us to confirm stock before ordering. Once sold out, this board cannot be restocked from any manufacturer channel. If you need this part, don't wait.

Part WD21X24901C Replaces a83232, ffe0e0, WD21X24901, 4444444444444444, 1777040489, c8a400, f0f0f0

GE Dishwasher Dishwasher Control Board WD21X24901C

Is This the Right Part?

Part NumberWD21X24901C
Replacesa83232, ffe0e0, WD21X24901, 4444444444444444, 1777040489, c8a400, f0f0f0
ManufacturerGE
Appliance TypeDishwasher

Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, hose positions, electrical ratings, or mounting points.

  • Dishwasher completely dead — no lights, no display, no response to any button
  • Dishwasher won't start even though it has power
  • Cycle starts but stops partway through without completing
  • Control panel buttons unresponsive or intermittently working
  • Display blank, flickering, or showing persistent error codes
  • Incorrect cycle timing — wash runs too long or cuts off too early
  • Water temperature not reaching correct level during wash
  • Dishwasher randomly resets or changes cycles mid-wash
  • OEM Part Number: WD21X24901C
  • Replaces: WD21X24901
  • Part Type: Dishwasher Machine Control Board (Main Control Board / Electronic Control Module / Cycle Control Board)
  • Status: No Longer Available (NLA) — discontinued by GE, cannot be reordered
  • Condition: Genuine OEM — new in manufacturer packaging
  • Controls: Cycle selection, water temperature, wash timing, safety interlocks, display output
  • Platform: GE dishwashers
  • Common Failure Causes: Power surges, relay fatigue, moisture intrusion, age-related component failure
  • Skill Level: Intermediate — inner door panel removal and harness connector transfer required
  • Always disconnect power at the breaker before servicing — do not rely on the dishwasher's power switch alone
  • The machine control board is typically located behind the inner door panel — remove door screws to access
  • Photograph all harness and ribbon connector positions before disconnecting the old board
  • Handle the control board by its edges only — circuit components are static-sensitive
  • Transfer connectors one at a time to avoid mis-wiring
  • Do not overtighten mounting screws — board standoffs are plastic and will crack
  • After installation, restore power and run a full test cycle before closing the door panel
  • NLA note: Confirm stock availability with XPart Supply before ordering — this part cannot be exchanged for a restock if unavailable
💡 Pro Tip — Check the Door Latch and Thermal Fuse Before Ordering This NLA Board:
A failed door latch switch is the most common cause of a dishwasher that won't start — and it looks identical to a dead control board. The dishwasher will not begin any cycle if it doesn't detect a fully latched door. Test the door latch switch for continuity with a multimeter before ordering. Also check the thermal fuse — a blown fuse cuts all power to the control board and produces a completely dead panel. Both are inexpensive parts under $20. Because this is an NLA board that cannot be returned once installed in most cases, rule these out first. Order the board only after confirming the latch and fuse test good.

Part Details

Part TypeDishwasher Control Board
ConditionOEM

Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.

Buy Online Pick Up In-Store

Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Phone
1-877-899-7278
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
Get Directions
Map showing warehouse location at 101 Trillium Dr, Kitchener
View on Google Maps

What Customers Say

4.70 ★ (288)
Verified

All brand names are the property of their respective owners and are used for compatibility reference only.

WD21X24901C, a83232, ffe0e0, WD21X24901, 4444444444444444, 1777040489, c8a400, f0f0f0