Menu
✓ Is This the Part You Need?
This is the genuine OEM bake burner element for GE, GE Profile, Café, and Monogram ovens. The bake element is the lower heating element responsible for preheating and baking. When it fails, the oven won’t reach temperature, bakes unevenly, or won’t heat at all. This is a special order part — please contact us to confirm availability and lead time before ordering.
✓ Symptoms This Fixes
- Oven not heating or won’t reach set temperature
- Oven takes much longer than normal to preheat
- Food baking unevenly — burnt on top, undercooked on bottom
- Visible cracks, holes, or burn marks on the lower element
- Element glows only partially or not at all
- Oven trips the breaker when bake mode is selected
✓ Part Details
- OEM Part Number: WS01F08528
- Element type: Bake (lower) burner element
- Special order — not stocked; sourced directly from GE. Contact us to confirm lead time.
- Genuine GE OEM — factory-specified wattage and fit for compatible models
✓ Installation Notes
- Skill level: 2/5 — basic hand tools required
- Estimated time: 20–30 minutes
- ⚠ Disconnect power at the breaker before servicing — bake elements carry high voltage
- Remove oven racks and unscrew the element mounting bracket from the oven floor
- Pull the element forward carefully to expose the wire terminals — do not pull on the wires
- Disconnect the terminal connectors and transfer to the new element
- Confirm the element seats flush against the back wall before securing the bracket
- Restore power and run a bake cycle to confirm even heating before use
✓ Compatible Models
Compatible with select GE, GE Profile, Café, and Monogram ranges and wall ovens. Verify your full model number before ordering. Contact us to confirm compatibility and lead time for this special order part.
💡 Pro Tip — Test the Element Before Ordering a Special Order Part:
Before committing to a special order, confirm the bake element is the actual failure point. With the oven unplugged, use a multimeter set to resistance (ohms) and probe the two element terminals — a working bake element typically reads 20–50 ohms. An open circuit (OL/infinite resistance) confirms the element has burned out. Also visually inspect for cracks, blistering, or holes in the element surface — any visible damage is a definitive failure. If the element tests good, the fault may be in the control board or temperature sensor instead.
Before committing to a special order, confirm the bake element is the actual failure point. With the oven unplugged, use a multimeter set to resistance (ohms) and probe the two element terminals — a working bake element typically reads 20–50 ohms. An open circuit (OL/infinite resistance) confirms the element has burned out. Also visually inspect for cracks, blistering, or holes in the element surface — any visible damage is a definitive failure. If the element tests good, the fault may be in the control board or temperature sensor instead.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
- Choosing a selection results in a full page refresh.
