GE Oven Not Heating or Baking Unevenly? Bake Element WS01L18573 – Fix It Fast

A failed bake element is the most common reason a GE oven stops heating on the bake cycle or produces uneven, undercooked results. In most GE ranges and wall ovens, the spreader main bake element distributes heat evenly across the oven floor — when it burns out or cracks, the oven won’t reach temperature, food bakes unevenly, or the breaker trips when the bake cycle is activated. ⚡ Common failure point in GE-built ranges and wall ovens. Part WS01L18573 is the genuine OEM replacement that restores full bake heat and even temperature distribution immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your oven powers on and the control panel and clock function normally
• ✔ The broil element works correctly — only the bake cycle is affected
• ✔ The oven temperature sensor has been confirmed functional (reads ~1080Ω at room temp)
• ✔ The oven control board is intact with no visible burn marks or error codes
• ✔ ONLY problem is no heat on bake, slow preheat, or uneven baking results

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Oven not heating on bake cycle — most common customer complaint
• Oven takes much longer than normal to preheat
• Food undercooked on the bottom, overcooked on top
• Visible burn marks, blistering, or a break in the element coil
• Breaker trips when bake cycle is activated
• F7 or bake element fault code displayed on the control panel

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this bake element restores full oven heat and even baking immediately.

📦 Part Details

• Part Number: WS01L18573
• Type: Spreader Main Bake Element (Oven Bake Element)
• Condition: New — Genuine OEM
• Brands: GE, GE Profile, Café (General Electric)

⚙️ Installation

Skill Level: Easy — 15–25 minutes. Disconnect power at the breaker before beginning — do not rely on the oven’s power switch alone. Allow the oven to cool completely, then remove the two mounting screws at the back of the oven cavity, pull the element forward, disconnect the two wire terminals (photograph the wiring first), and connect the new element in reverse order. Ensure both terminal connections are fully seated before restoring power and running a test bake cycle.

✓ Compatible Models

Confirmed compatible with select GE, GE Profile, and Café range and wall oven models. Contact us to verify your model number before ordering.

💡 Pro Tip

See all parts, cross-references, and model compatibility: WS01L18573 Part Hub

✓ Model-Specific Repair Pages