Washer Not Spinning Properly? Spin Basket AJQ73674410 — Fix Uneven Loads & Poor Drainage Fast
A cracked, warped, or damaged spin basket is the leading cause of off-balance loads, excessive vibration, and incomplete drainage in LG front-load and top-load washers. In most LG washers, the spin basket is the perforated inner tub that holds the laundry load and rotates at high speed to extract water. When it fails or is damaged, the washer vibrates violently, throws error codes, fails to spin up to speed, or leaves clothes soaking wet after the cycle. ⚡ Common damage point in high-capacity LG washers subject to overloading or foreign object impact. Part AJQ73674410 is the genuine OEM replacement spin basket that restores balanced, high-speed spinning and proper water extraction to factory specification.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Washer powers on and fills with water normally
- ✔ Drive motor and bearings are confirmed functional
- ✔ Drain pump is working — water exits the machine
- ✔ ONLY problem is violent vibration, off-balance errors, or the basket is visibly cracked or damaged
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Washer shakes violently or walks across the floor during spin cycle
- UE, OE, or off-balance error codes during spin
- Clothes still soaking wet after a full spin cycle
- Visible cracks, chips, or deformation on the inner basket
✔ If these symptoms match, the spin basket is the most likely failed component in the system.
✔ In most cases, replacing the AJQ73674410 basket eliminates vibration and restores full spin performance immediately.
📦 Part Details
- Part Number: AJQ73674410
- Type: OEM Inner Spin Basket / Perforated Tub Assembly — LG Washer
- Replaces: AJQ73674410 (confirm additional cross-references with your model number)
- Brands: LG
While the basket is out, inspect the drum bearings and spider arm assembly for wear or damage — a failed spider arm is a common companion failure that causes the same vibration symptoms and will destroy a new basket if left in place. Contact us for the compatible bearing and spider arm part numbers for your model.
⚙️ Installation
Skill Level: ADVANCED — 2–4 hours. Disconnect power and water supply before servicing. Wear work gloves throughout — basket edges are sharp. Full disassembly of the outer tub is required to access and replace the inner spin basket. Remove the door boot seal, front panel, outer tub bolts, and counterweights to extract the basket assembly. Install the AJQ73674410, reassemble in reverse order, and run a calibration cycle before returning the washer to service.
✓ Compatible Models
Compatibility is confirmed by model number — this is a large, model-specific component. Contact us to verify your model number before ordering. Due to the size and weight of this part, freight shipping applies — we will contact you with shipping details after your order is placed.
💡 Pro Tip
The spider arm (the three-pronged bracket that connects the basket to the bearing shaft) fails at a similar rate to the basket itself on high-mileage LG washers. Labour to access both parts is identical — replacing only the basket and leaving a worn spider arm means you'll be back inside the machine within 6–12 months. Order both together and do the job once.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
