Washer Leaking from the Door? Boot Seal MDS66290813 – Fix Front-Load Door Leaks Fast

A torn, cracked, or mould-damaged door boot seal is the leading cause of water leaking from the front of an LG front-load washer. In most LG front-load washers, the door boot seal (also called the door gasket or bellows) creates an airtight, watertight barrier between the door glass and the drum opening. When it fails, water escapes onto the floor during every wash cycle — and mould buildup in the folds accelerates the damage further. ⚡ One of the most common wear items in LG front-load washers. Part MDS66290813 is the genuine OEM replacement boot seal that restores a watertight door seal, eliminates leaks, and returns your washer to factory performance.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and runs cycles normally
• ✔ Water supply and drain hoses are intact and properly connected
• ✔ Door latch closes and locks correctly
• ✔ ONLY problem is water leaking from the front door area during or after a cycle

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Water pooling on the floor in front of the washer during or after a cycle
• Visible tears, cracks, or holes in the rubber door gasket
• Black mould or mildew buildup in the gasket folds that won’t clean off
• Musty smell coming from the door seal area

✔ If these symptoms match, this is the most likely failed component causing the leak.

✔ In most cases, replacing this door boot seal eliminates the leak immediately and restores a clean, watertight door closure.

📦 Part Details

• Part Number: MDS66290813
• Type: Washer Door Boot Seal / Door Gasket / Bellows — rubber seal between door glass and drum opening
• Replaces: MDS66290828 — direct OEM replacement, no modification required
• Brands: LG

⚙️ Installation

Skill Level: Moderate — 45–60 minutes. Disconnect power and water supply before servicing. Remove the door seal retaining spring clip from the front of the tub opening, peel the old boot seal away from the drum lip and door frame, and clean the mounting surfaces thoroughly. Seat the new MDS66290813 seal onto the drum lip first, then work the outer lip into the door frame groove and reinstall the retaining spring clip. Run a short cycle and inspect for leaks before returning to service.

✓ Compatible Models

Confirmed compatible with LG front-load washer models using the MDS66290828 door boot seal. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages