VERIFIED PART INFORMATION
Panasonic 27-inch Stainless Steel Microwave Trim Kit NNTK922S
Panasonic 27-inch stainless steel trim kit for converting compatible 2.2 cu. ft. countertop microwave ovens to built-in installations.
Part NNTK922SPanasonic
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberNNTK922S
ManufacturerPanasonic
Appliance TypeMicrowave
Part Type27-inch Stainless Steel Microwave Trim Kit
Check Before Replacing
- Confirm the microwave model is listed as compatible by Panasonic before ordering.
- Measure the cabinet opening: approximately 25 1/2 inches wide, 17 3/8 inches high, and at least 21 inches deep.
- Confirm the trim kit’s 27-inch outside width and 18 9/16-inch outside height match the installation location.
Pro Tip
Do not select this kit by cabinet width alone; Panasonic specifies compatibility by microwave model and cabinet-opening dimensions.
Part Details
Part NumberNNTK922S
Part Type27-inch Stainless Steel Microwave Trim Kit
ManufacturerPanasonic
Appliance TypeMicrowave
Primary FunctionProvides the trim frame and duct components needed to install a compatible Panasonic microwave in a cabinet opening.
Installation Notes
- Use only with Panasonic microwave models documented as compatible with this trim kit.
- Required cabinet opening is approximately 25 1/2 inches wide by 17 3/8 inches high, with at least 21 inches of depth.
- Panasonic lists a minimum installation height of 36 1/4 inches from the floor.
- Installation documentation lists a measuring tape, pencil, Phillips screwdriver, and 2 mm drill as tools.
Verified Compatible Models
Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
