Washer Not Draining or Agitating? Belt & Pump Kit RB150003 – Fix Both Fast
When a Speed Queen washer loses both agitation and drainage, the belt and pump are the first components to inspect — and replacing them together is the correct repair. In most Speed Queen top-load washers, the drive belt transfers motor power to the transmission and pump simultaneously — when the belt slips or breaks, both agitation and draining stop at once. ⚡ Common combined failure point in Speed Queen and Alliance Laundry-built washers. Kit RB150003 is the OEM belt and pump assembly that restores full wash and drain function in a single repair visit.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your washer powers on and the motor runs — but drum does not agitate
- ✔ Water is not draining at the end of the cycle
- ✔ Drain hose is clear and not kinked or blocked
- ✔ Lid switch is functioning correctly
- ✔ ONLY problems are failed agitation and/or drainage — not a complete no-power failure
Not sure? Send us your model number — we’ll confirm before you order.
🔧 Common Symptoms
- Washer fills with water but drum does not agitate
- Washer won’t drain — standing water remains after cycle
- Motor runs but no mechanical action in drum or pump
- Loud squealing or slipping noise before agitation stops
- Clothes soaking wet after full cycle — no spin or drain
- Burning rubber smell from cabinet during operation
✔ If these symptoms match, this is the most likely failed component combination in the system.
✔ In most cases, replacing this belt and pump kit restores full wash and drain operation immediately.
📦 Part Details
- Part Number: RB150003
- Type: Washer Drive Belt and Drain Pump Kit — OEM combination repair kit
- Includes: Drive belt and drain pump assembly (no modification required)
- Brands: Speed Queen, Alliance Laundry Systems
While the cabinet is open, inspect the motor pulley and idler arm for wear — a worn pulley groove accelerates belt wear and will shorten the life of the new belt significantly. Replacing the pulley at the same time is a low-cost step that prevents a repeat repair within a year.
⚙️ Installation
Skill Level: Moderate — 45–60 minutes. Disconnect power and water supply before beginning. Remove the cabinet panels to access the motor, pump, and belt routing. Disconnect the old pump harness and hose clamps, remove the worn belt from the motor and transmission pulleys, install the new pump and route the new belt per the original path, then reassemble. Run a full cycle to confirm both agitation and drainage before closing the cabinet.
✓ Compatible Models
Compatible with select Speed Queen and Alliance Laundry top-load washer models. Contact us with your model number to confirm fitment before ordering — we’ll verify compatibility for you.
💡 Pro Tip
Ordering the belt and pump as a kit (RB150003) rather than individually ensures both components are the same generation and tolerances — mismatched parts from different production runs can cause premature wear. If your washer is 7+ years old, the kit repair is the correct approach and typically costs less than two separate service calls.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
