Bathroom Fan Not Moving Air or Making Noise? Motor Kit PWS100HEMBB – Fix Ventilation Failure Fast
A failed motor is the most common reason a Reversomatic PWS100HE bathroom exhaust fan stops moving air, runs loudly, or hums without spinning. In the PWS100HE, the motor, blade, and bracket work as an integrated assembly — when the motor burns out or the blade cracks, the entire unit loses effectiveness and must be replaced as a kit. When it fails, moisture builds up in the bathroom, mold risk increases, and the fan either runs silently or not at all. ⚡ Common failure point in Reversomatic PWS100HE bathroom ventilation fans. Part PWS100HEMBB is the genuine OEM motor, blade, and bracket replacement kit that restores full airflow and quiet operation immediately — without replacing the entire fan housing.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your fan model is the Reversomatic PWS100HE
- ✔ The fan housing and grille are intact and undamaged
- ✔ Power to the fan is confirmed (breaker on, switch working)
- ✔ The only problem is the motor not spinning, weak airflow, or excessive noise from the motor/blade assembly
Not sure? Send us your model number — we’ll confirm before you order.
🔧 Common Symptoms
- Fan hums but blade doesn’t spin or spins very slowly
- Fan runs but airflow at the vent is noticeably weak
- Loud grinding, rattling, or squealing noise from the fan
- Fan blade wobbles or is visibly cracked or damaged
- Bathroom moisture and condensation not clearing after a shower
- Fan stops working intermittently or fails to start
✔ If these symptoms match, the motor/blade/bracket assembly is the most likely failed component.
✔ In most cases, installing this kit restores full quiet operation immediately.
📦 Part Details
- Part Number: PWS100HEMBB
- Type: Bathroom Exhaust Fan Motor, Blade & Bracket Replacement Kit
- Fits Model: Reversomatic PWS100HE
- Kit Includes: Motor, fan blade, and mounting bracket
- Brand: Reversomatic (Genuine OEM)
While the fan is disassembled, inspect the duct connection and exterior vent cover for lint buildup or blockage. A blocked duct reduces airflow even with a new motor — a quick duct cleaning at the same time ensures the new kit performs at full capacity from day one.
⚙️ Installation
Skill Level: EASY — 20–30 minutes. Turn off the circuit breaker to the bathroom fan before beginning. Remove the grille cover, disconnect the wiring harness from the old motor, unscrew the mounting bracket, and slide out the motor and blade assembly. Install the new PWS100HEMBB kit by reversing these steps — secure the bracket, reconnect the harness, and snap the grille back into place. Restore power and run the fan to confirm full airflow and quiet operation. No special tools required.
✓ Compatible Models
This kit is confirmed compatible with the Reversomatic PWS100HE bathroom ventilation fan. Contact us to verify your model number before ordering if you are unsure of your exact fan model.
💡 Pro Tip
Replacing only the motor without the matched blade and bracket can cause vibration, noise, and reduced airflow due to balance tolerances. The PWS100HEMBB kit is factory-matched — installing all three components together ensures quiet, efficient operation and avoids a repeat service call.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
