Range Hood Fan Not Running or No Suction? Broan Motor Assembly S10941066 – Fix Weak Airflow Fast
A failed range hood motor assembly causes your Broan or NuTone range hood to lose suction, run at only one speed, make grinding or humming noises, or stop working entirely — leaving smoke, grease, and cooking odours trapped in your kitchen. In most Broan-built range hoods, this is caused by a failed motor assembly — the 2-speed blower motor that drives the exhaust fan and pulls air through the grease filters and ductwork. When it fails, the fan may not start, run only on one speed, vibrate excessively, or hum without spinning, and ventilation performance drops to zero. ⚡ The most common mechanical failure in Broan and NuTone range hoods. Part S10941066 is the genuine OEM replacement that restores full 2-speed exhaust performance and quiet operation immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Range hood powers on and lights function normally
- ✔ Speed selector switch responds (clicks or changes setting)
- ✔ Grease filters are not severely clogged or blocking airflow
- ✔ ONLY problem is the fan won't run, runs on only one speed, makes grinding/humming noise, or has significantly reduced suction
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Range hood fan won't turn on at either speed
- Fan runs on low speed only — high speed does nothing
- Grinding, rattling, or loud humming noise from the hood
- Weak or no suction — smoke and odours not being captured
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this motor assembly restores full 2-speed ventilation and quiet operation immediately.
📦 Part Details
- Part Number: S10941066
- Type: Range Hood Blower Motor Assembly — 2-Speed Exhaust Fan Motor
- Replaces: 10941066, 10941067, 400260, 400261, 30080432, K6970000, K7284000, HVA118C, R7-RB109
- Brands: Broan, NuTone
While the motor is out, clean or replace the grease filters — heavily saturated filters restrict airflow and cause the new motor to work harder, shortening its lifespan. Replacing filters at the same time maximizes ventilation performance and protects your investment in the new motor.
⚙️ Installation
Skill Level: MODERATE — 20–40 minutes. Phillips screwdriver and wire connectors required. Disconnect power at the breaker before servicing. Remove the grease filters and unscrew the motor mounting bracket from inside the hood cavity. Disconnect the wiring harness from the old motor, transfer the fan blade to the new S10941066 assembly if required, connect the wiring, and secure the motor back into the mounting bracket. Restore power and test both speed settings.
✓ Compatible Models
Confirmed compatible with select Broan and NuTone range hood models that use the 10941066 or 10941067 motor assembly, including models in the 400 series and related product lines. Contact us to verify your model number before ordering.
💡 Pro Tip
If the fan runs on one speed but not the other, the 2-speed selector switch may be the actual fault — not the motor. Test the switch for continuity at each position before ordering the motor assembly. If both speed positions on the switch test good and the motor still won't run at high speed, the motor winding is failed and S10941066 is your fix.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
