Samsung Range Burner Not Responding or Heating Unevenly? Surface Element Control Switch DG44-01001A – Fix Erratic Burner Behaviour Fast
A burner that won't respond, heats at the wrong level, or cycles on and off erratically is almost always a failed surface element control switch. In most Samsung electric ranges, the surface element control switch (also called an infinite switch) translates the knob position into a precise heat signal for the burner element. When it fails, the burner loses accurate heat control — it may not respond at all, stay stuck on high, or cycle unpredictably during cooking. ⚡ Common failure point in Samsung-built electric ranges. Part DG44-01001A is the genuine OEM surface element control switch that restores accurate, responsive burner control.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Range powers on and other burners work normally
- ✔ The affected burner element tests good (continuity confirmed with multimeter)
- ✔ Wiring harness at the switch is intact — no burned pins or broken connectors
- ✔ ONLY problem is the burner not responding, heating wrong, or cycling erratically
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Burner does not respond when knob is turned
- Burner heats at the wrong level regardless of knob position
- Burner cycles on and off erratically during cooking
- Burner stays on high or won't turn off
- Knob turns freely but no heat change occurs at the element
- Burning smell or visible scorching at the switch location behind the control panel
✔ If these symptoms match, the surface element control switch is the most likely failed component.
✔ In most cases, replacing this switch restores full, accurate burner control immediately.
📦 Part Details
- Part Number: DG44-01001A
- Type: Surface Element Control Switch (Infinite Switch)
- Replaces: DG44-01001A (OEM — no known aftermarket cross-reference)
- Brands: Samsung
- Status: ⚠️ Discontinued / No Longer Available (NLA) — used pulls only
While the control panel is open, test the surface element itself for continuity. A burned-out element mimics a failed switch — if the element has an open circuit, a new switch won't restore heat. Confirm element continuity before closing up. If the element is bad, order a replacement element at the same time to avoid a second service call.
⚙️ Installation
Skill Level: MODERATE — 20–40 minutes. Disconnect power at the breaker before servicing — do not rely on the knob being in the off position. Remove the range control panel (typically 4–6 screws at the rear or underside), photograph the wiring harness terminal positions before disconnecting, then swap in the replacement switch and reconnect in the same positions. Reassemble the panel, restore power, and test all heat settings on the repaired burner.
✓ Compatible Models
Confirmed compatible with NE595R0ABSR, NX58F5500SS, NX58H5600SS, FTQ352IWUW, FX710BGS plus additional Samsung electric range models. Contact us to verify your model number before ordering.
💡 Pro Tip
Before ordering a control switch, test the surface element itself with a multimeter set to continuity or resistance. A burned-out element can mimic a failed switch — if the element has an open circuit, replacing the switch won't restore heat. Confirm the element is good first, then replace the switch. This saves a second service call and a second part order. If both the switch and element are suspect, replace both at the same time while the panel is already open.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
