Washer Won’t Start or Complete a Cycle? Control Board W10215443 – Fix No-Start & Cycle Errors Fast

When your Whirlpool or Maytag top-load washer won’t start, stops mid-cycle, or displays error codes, the main electronic control board is the primary suspect. In most Whirlpool-built top-load washers, this is caused by a failed control board. When it fails, the washer may not respond to any input, cycle selection becomes erratic, and the machine can stop at any point in the wash sequence. ⚡ Common failure point in Whirlpool-built top-load washers. Part W10215443 is the genuine OEM replacement that restores full electronic control and reliable cycle operation.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on but won’t start a cycle or stops unexpectedly
• ✔ Lid switch and door latch test OK and are not the source of the fault
• ✔ Household power supply and outlet confirmed good
• ✔ Motor and pump operate when manually tested
• ✔ ONLY problem is unresponsive controls, failed cycle progression, or persistent error codes

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Washer won’t start when cycle is selected — most common, what customers search first
• Washer stops mid-cycle and won’t resume
• Control panel buttons unresponsive or erratic
• Washer fills with water but agitator or spin drum won’t engage
• F or E error code displayed and won’t clear (e.g. F5E3, F7E1)
• Washer runs continuously without advancing through cycle stages

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this control board restores normal operation immediately.

📦 Part Details

• Part Number: W10215443
• Type: Main Electronic Control Board (PCB Assembly)
• Replaces: OEM direct-fit control board — supersedes W10189966, W10215443RP, 8182706, 8182707 (no modification required)
• Brands: Whirlpool, Maytag, Kenmore

⚙️ Installation

Skill Level: MODERATE — 20–40 minutes. Disconnect power before beginning — unplug the washer or shut off the breaker. Remove the control panel housing (typically 2–4 screws at the rear), photograph all wiring harness connections before disconnecting, swap the board, and reconnect all harnesses in reverse order. Restore power and run a diagnostic cycle to confirm normal operation before returning to regular use.

✓ Compatible Models

Compatible with select Whirlpool, Maytag, and Kenmore top-load washer models. Contact us with your model number to confirm fitment before ordering.

💡 Pro Tip

Find model-specific repair guides and compatible parts for your washer: contact us with your model number to be linked to the correct hub page.