CERTIFIED PRE-OWNED PART
Whirlpool Dishwasher W10280784, Replaces a83232
When the upper rack on your Whirlpool dishwasher collapses, derails, or has broken tines, dishes on the top level stop getting cleaned — and sharp broken plastic becomes a hazard every time you load. The W10280784 upper rack is the genuine OEM replacement for affected models, but this part has been discontinued by the manufacturer and is no longer available new. We carry limited used stock while it lasts. Once it's gone, it's gone.
Part W10280784
Replaces a83232, ffe0e0, c8a400, f0f0f0, W10203930
Is This the Right Part?
Part NumberW10280784
Replacesa83232, ffe0e0, c8a400, f0f0f0, W10203930
ManufacturerWhirlpool
Appliance TypeDishwasher
Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, hose positions, electrical ratings, or mounting points.
- Upper rack collapses or won't stay level on the tracks
- Rack derails or falls when pulled out
- Tines broken, bent, or missing — dishes tip and don't get cleaned
- Rack adjuster clips broken causing the rack to sit too high or too low
- Plastic coating worn through, causing rust contamination on dishes
- Rack won't roll smoothly on the upper rack rollers
- OEM Part Number: W10280784
- Replaces: W10203930
- Manufacturer: Whirlpool
- Compatible Brands: Whirlpool, Kenmore, KitchenAid, Maytag, Amana, Jenn-Air
- Condition: Used — inspect photos carefully before ordering
- Availability: NLA — discontinued by manufacturer. Limited used stock only.
- Skill Level: Beginner — no tools required
- Estimated Time: 5–10 minutes
- Pull the old rack fully out and lift off the track rollers
- Transfer any adjuster clips or roller assemblies from the old rack if not included
- Confirm rack height adjuster compatibility with your model before ordering
- No need to disconnect power for this repair
💡 Pro Tip — Check the Upper Rack Rollers and Adjuster Clips:
If your rack was derailing or sitting crooked, the rollers and adjuster clips are likely worn too. Replacing just the rack without addressing worn rollers means the new rack will derail again. Search your model number for the upper rack roller kit and adjuster clips — these are usually still available even when the rack itself is NLA.
If your rack was derailing or sitting crooked, the rollers and adjuster clips are likely worn too. Replacing just the rack without addressing worn rollers means the new rack will derail again. Search your model number for the upper rack roller kit and adjuster clips — these are usually still available even when the rack itself is NLA.
Part Details
ConditionCertified Pre-Owned
Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
