If your Whirlpool or Maytag front-load washer is banging, vibrating excessively, or walking across the floor during the spin cycle, worn shock absorbers are the most common cause. Part number W10739670 is the correct OEM replacement shock absorber kit for a wide range of WFW and MHWZ series front-load washers — available in a 4-pack (full replacement set) or 2-pack.

✓ Model-Specific Repair Pages

The W10739670 shock absorber is a hydraulic damper that cushions the drum during high-speed spin cycles. Over time, the internal fluid seal degrades, causing the absorber to lose its damping ability — resulting in loud banging, excessive vibration, and premature wear on the drum bearings and spider arm. Replacing all four at once ensures balanced damping and prevents uneven wear.

✓ Common Symptoms Fixed

Loud banging or thumping during spin cycle — Washer vibrating excessively or moving across the floor — Drum hitting the cabinet walls — Unbalanced load errors on models with load sensors — Premature bearing or spider arm wear

✓ Key Features & Specifications

OEM part number: W10739670 — Replaces: 8540852, W10084740, W10480711 — Sold as a 4-pack (full set) or 2-pack — Hydraulic shock absorber design — Compatible with Whirlpool and Maytag front-load washers (WFW and MHWZ series) — Direct OEM fit, no modification required

✓ Buying Options

OEM (New): Genuine Whirlpool/Maytag factory part. Full manufacturer specifications, full lifespan. Available in 4-pack or 2-pack.

Used (Tested): Inspected and tested used OEM shock absorbers. A cost-effective option for older machines or budget repairs. Available in 4-pack or 2-pack.

✓ Replacement Part Numbers

W10739670 (OEM) — 8540852 — W10084740 — W10480711

✓ Installation Tips

Disconnect power before beginning any repair. Remove the front panel to access the shock absorbers — they are mounted between the outer tub and the base frame. Replace all four absorbers at the same time to maintain balanced damping. Torque mounting bolts to spec and verify the drum moves freely before reassembling. Run a spin cycle test before closing the cabinet.