DISHWASHER FILLS BUT HAS LITTLE OR NO SPRAY-ARM WATER PRESSURE
Whirlpool Dishwasher Circulation pump and motor assembly W10894668, Fixes Dishwasher fills but has little or no spray-arm water pressure
Whirlpool OEM circulation pump and motor assembly that delivers wash water to the dishwasher spray arms.
Part W10894668Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW10894668
ManufacturerWhirlpool
Appliance TypeDishwasher
Part TypeCirculation pump and motor assembly
✅ Cross Reference Information
Current Part NumberW10894668
Common Symptoms
- Poor cleaning performance despite normal filling
- Spray arms not spinning or receiving weak water pressure
- Loud droning, humming, groaning, or grinding noise during washing
- Dishwasher fills but does not produce normal washing action
- Possible leakage near the circulation-pump or motor area
Check Before Replacing
- Confirm that the dishwasher fills with water before the wash portion begins; a fill problem can mimic a circulation-pump problem.
- With power disconnected, inspect and clean the filters and check that spray-arm openings are not blocked; clogs can cause weak spray pressure without a failed pump.
- After restoring power, observe or listen during the wash phase for normal circulation noise and spray-arm movement, while keeping hands away from moving or energized components.
- Inspect the pump and nearby connections for visible cracking or active leakage; do not assume a leak is caused by this assembly without locating its source.
- Use the appliance's model-specific diagnostic cycle, if available, to check for a wash-motor or circulation-pump fault; diagnostic procedures vary by model.
Pro Tip
Before replacing the pump, rule out clogged filters, blocked spray arms, and a separate drain-pump or diverter problem, because those issues can produce similar cleaning or noise symptoms.
Part Details
Part NumberW10894668
Part TypeCirculation pump and motor assembly
ManufacturerWhirlpool
Appliance TypeDishwasher
Primary FunctionCirculates pressurized wash water through the dishwasher spray-arm system during wash and rinse portions of the cycle.
Installation Notes
- Disconnect electrical power and shut off the dishwasher water supply before servicing.
- Access and removal steps vary by dishwasher model; follow the model-specific service or installation documentation.
- Inspect the mating area, pump housing, wiring connector, hoses, and seals for damage before installing the replacement.
- Reconnect all electrical and water connections securely, then run a short cycle and check for leaks before returning the dishwasher to service.
- If the assembly or surrounding sump area is cracked, leaking, or difficult to access, use a qualified appliance technician.
Verified Compatible Models
66512763K311, 66512763K314, 66512776K315, 66514715N710, 66514752N511, 66514753N511, 66514754N511, 66514754N512, 66514759N511, 66514759N512, 66514792N511, 66514792N512, 66514793N511, 66514793N512, 66514799N511
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
All brand names are the property of their respective owners and are used for compatibility reference only.
