Fasteners Backing Out? Thread Locker Sealant W10898074 – Stop Vibration Loosening Fast
If bolts, screws, or fasteners on your appliance keep loosening from vibration — or you're reassembling a component that requires thread-locking compound — this is the correct OEM sealant. In Whirlpool, Maytag, and KitchenAid appliances, medium-strength thread locker is specified for motor mounts, pump housings, agitator bolts, and other vibration-prone fasteners. Without it, fasteners back out over time, causing rattles, leaks, or component failure. ⚡ Required during reassembly of many Whirlpool-built appliance components. Part W10898074 is the genuine OEM medium-strength thread locking sealant that holds fasteners securely while still allowing removal with standard hand tools.
❓ Is This the Right Part?
This is the correct product if ALL of the following are true:
- ✔ You are reassembling a Whirlpool, Maytag, or KitchenAid appliance component
- ✔ Your service manual or parts diagram specifies thread locker or thread locking compound
- ✔ The fastener size is compatible with medium-strength thread locker (most M4–M12 bolts)
- ✔ You need a removable bond — not permanent high-strength adhesive
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Applications
- Motor mount bolts backing out from vibration during operation
- Pump housing fasteners loosening and causing leaks
- Agitator bolt or wash plate reassembly requiring thread locker
- Any fastener specified as requiring Loctite or thread locking compound in the service manual
✔ If your repair calls for thread locking compound, this is the correct OEM-specified product.
✔ Medium-strength formula holds securely under vibration but releases cleanly with standard hand tools when needed.
📦 Part Details
- Part Number: W10898074
- Type: Medium-Strength Thread Locker Sealant — 15ml bottle, OEM appliance grade
- Replaces: LOKPREP65G, LOKPREP65G/15, W10894070
- Brands: Whirlpool, Maytag, KitchenAid, Amana, Jenn-Air
If you're using thread locker during a pump or motor reassembly, also inspect the door boot seal and tub bearing while the machine is open — these are common companion wear items that are much easier to replace with the appliance already disassembled.
⚙️ Application Instructions
Skill Level: EASY — 2–5 minutes application time, 1 hour cure before operation. Clean fastener threads thoroughly with a degreaser and allow to dry completely before applying. Apply a small drop (1–2mm bead) to the first few threads of the fastener — do not over-apply. Thread the fastener in and torque to spec. Allow minimum 1 hour cure time before operating the appliance; full cure in 24 hours.
✓ Compatible Applications
This OEM thread locker is specified across a wide range of Whirlpool, Maytag, and KitchenAid washers, dryers, dishwashers, and refrigerators wherever thread locking compound is called for in the service documentation. Contact us to verify your application before ordering.
💡 Pro Tip
A single small drop on the first 2–3 threads is all you need. Excess compound squeezes out, can migrate into bearings or seals, and makes future disassembly harder. When in doubt, apply less — the clamping force of the fastener spreads the compound evenly once tightened.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
