Whirlpool Washer Water-level pressure switch W11044866, Replaces W10597311

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Washer continues filling or may overflow
• Washer does not fill to the expected level
• Cycle may stop, fail to advance, or produce long-fill or long-drain behavior
• Washer may not start or may stop during a cycle

Check Before Replacing

• Unplug the washer before inspecting the switch, wiring, or pressure hose.
• Visually inspect the pressure hose and its connections for leaks, pinching, kinks, water, suds, or debris.
• Verify that the electrical connector and pressure-switch harness are fully seated and show no visible damage or corrosion.
• If qualified to perform electrical testing, follow the washer's model-specific technical sheet for pressure-switch continuity checks; do not assume a pressure-switch fault until the hose, wiring, and control circuit have also been checked.

Pro Tip

Part Details

Installation Notes

• Disconnect electrical power before service.
• Access and replacement procedures vary by washer model; use the model-specific service documentation.
• Before installing, compare the replacement switch and connector with the removed part.
• Reconnect the pressure hose and electrical harness securely, and route the hose without pinching or kinking it.
• After reassembly, run the applicable washer diagnostic or test cycle specified by the model documentation to verify correct filling and operation.

Verified Compatible Models

WFW3090GW0, WFW3090GW2, WFW3090JW0, WFW3090JW1, WFW5090GW0, WFW5090GW2, WFW5090JW0, WFW5090JW1, WFW3090GW

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.