Fridge Running Warm or Compressor Overheating? Condenser Fan Motor W11127829 – Fix Poor Cooling Fast

When your refrigerator isn't cooling properly, the freezer is warm, or the compressor runs hot and cycles off on thermal overload, a failed condenser fan motor is the most common cause. In most Whirlpool, KitchenAid, and Maytag refrigerators, the condenser fan motor draws air across the condenser coils and compressor to dissipate heat. When it fails, heat builds up in the compressor compartment, the compressor overheats and shuts down, and the entire refrigerator loses its ability to maintain temperature. ⚡ Common failure point in Whirlpool-platform bottom-freezer and side-by-side refrigerators. Part W11127829 is the genuine OEM replacement that restores proper condenser airflow, protects the compressor from thermal damage, and returns the refrigerator to full cooling performance.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Refrigerator powers on — lights, controls, and ice maker function normally
• ✔ Evaporator fan in the freezer is running — you can hear airflow inside
• ✔ Condenser coils are clean — not blocked by dust or debris
• ✔ ONLY problem is warm compartments, compressor overheating, or no airflow at the condenser

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Refrigerator and freezer not cooling or gradually warming up
• Compressor runs constantly or shuts off on thermal overload
• No airflow felt at the condenser vent / fan not spinning
• Loud rattling or grinding noise from the compressor compartment

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this condenser fan motor restores normal cooling immediately.

📦 Part Details

• Part Number: W11127829
• Type: Condenser Fan Motor (Compressor Compartment Cooling Fan)
• Replaces: W10527155, W10909387, W10917708, W11505535
• Brands: Whirlpool, KitchenAid, Maytag
• Application: Bottom-freezer, side-by-side, and French door refrigerators

⚙️ Installation

Skill Level: MODERATE — 20–40 minutes. Disconnect power before servicing. Access the condenser fan by removing the rear access panel or lower grille depending on model. Disconnect the wiring harness, remove the mounting bracket screws, and swap the motor. Confirm the fan blade is seated correctly on the new motor shaft, reassemble, restore power, and verify airflow at the condenser.

✓ Compatible Models

Confirmed compatible with ART318FFDB03, KRFF507HBS00, WRS571CIHV00, WRX988SIBH00, KRMF706EBS01, WRF767SDHV00 plus 57 additional Whirlpool, KitchenAid, and Maytag models. Contact us to verify your model number before ordering.

✓ Model-Specific Repair Pages

💡 Pro Tip