Whirlpool Washer Suspension Rod Kit W11130359, Replaces W10594082, W10785954, W10821704, W10901060, W11027215, W11033536, W11226784

OEM suspension rod kit for a top-load washer. The kit supports the wash tub and helps maintain stability during unbalanced loads.

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Tub banging or loud suspension-related noise during spin
• Repeated out-of-balance interruptions or error conditions
• Excessive tub movement or failure to remain centered
• Washer vibration or walking caused by loss of suspension control

Check Before Replacing

• Disconnect power before inspection.
• With the washer empty and power disconnected, visually inspect the suspension rods, springs, suspension balls, and retaining cups for visible breakage, deformation, looseness, or abnormal wear.
• Check whether the tub appears centered and supported evenly when the washer is empty; do not force the tub or operate the washer with panels removed.
• Confirm that the washer is level and that the symptom is not limited to an overloaded or unevenly distributed load.
• Verify the appliance model against the parts diagram before ordering or installing the kit; other suspension, leveling, drive, or tub components can produce similar symptoms.

Pro Tip

Part Details

Key Features

• Whirlpool genuine OEM suspension rod kit
• Kit includes four suspension rods with associated securing components
• Designed to stabilize the wash tub and reduce vibration during agitation and spin
• Manufacturer part number: W11130359
• Whirlpool lists W11130359 as replacing several earlier suspension-rod numbers, including W10594082, W10785954, W10821704, W10901060, W11027215, W11033536, and W11226784

Installation Notes

• Disconnect electrical power before beginning the repair.
• Use the washer model-specific service information or parts diagram for panel-access and rod-removal procedures; access requirements vary by model.
• Support or control the tub as suspension rods are removed so it does not drop unexpectedly.
• Install the rods and retaining components in the same locations and orientations shown by the model-specific parts documentation.
• Before reconnecting power, confirm that all four rods and their retaining components are securely seated and that no component is binding.
• After reassembly, test with a small, balanced load and stop the washer if abnormal movement or noise remains.

Verified Compatible Models

WTW7000DW0, WTW7000DW1, WTW7000DW2, WTW7000DW3, WTW7000DW4, WTW7040DW0, WTW7040DW1, WTW7040DW2, WTW7300DC0, WTW7300DW0, WTW7300DW1, WTW7300DW2, WTW7500GC0, WTW7500GC2, WTW7500GC3

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.