WATER LEAKING FROM THE DRYER DRAIN-HOSE PATH
Whirlpool Dryer discharge drain hose W11169712, Fixes Water leaking from the dryer drain-hose path
Whirlpool genuine OEM dryer discharge drain hose, approximately 72 inches long. It carries water extracted during the drying cycle to a household drain.
Part W11169712Replaces W10705660Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW11169712
ReplacesW10705660
ManufacturerWhirlpool
Appliance TypeDryer
Part TypeDryer discharge drain hose
✅ Cross Reference Information
Current Part NumberW11169712
ReplacesW10705660
Common Symptoms
- Water pooling near the dryer or drain connection
- Water not reaching the intended household drain
- Reduced or interrupted water flow caused by a kinked, crushed, or obstructed hose
- Loose hose connection or damaged hose allowing leakage
Check Before Replacing
- With the appliance unplugged, visually inspect the entire hose for kinks, crushing, cuts, abrasion, bulges, or wet spots.
- Check that both hose connections are fully seated and that any existing clamp or securing hardware remains in place.
- Confirm that the hose is routed to the intended drain without sharp bends or compression behind the appliance.
- During a monitored drain operation, look for leakage at the hose ends and along the hose; do not disassemble the appliance or handle electrical components unless qualified.
Pro Tip
Before replacing the hose, inspect the hose routing and both connection points; a kink or loose connection can restrict drainage or cause a leak even when the hose itself is intact.
Part Details
Part NumberW11169712
Part TypeDryer discharge drain hose
ManufacturerWhirlpool
Appliance TypeDryer
Primary FunctionCarries water extracted during the drying cycle from the dryer to a household drain.
Installation Notes
- Disconnect power before servicing or installation.
- Route the hose without kinks, crushing, or sharp bends, and ensure it reaches the intended drain location.
- Seat the hose fully at each connection and retain any original clamp or securing hardware.
- After installation, check the hose path and connections for leaks during operation.
- Follow the appliance-specific installation instructions because connection details may vary by dryer model.
Verified Compatible Models
WED99HEDC0, WED99HEDW0, WED7990FW0, WED9290FC0, WED9290FW0, WHD560CHW0, WHD560CHW1, WHD560CHW2, WHD862CHC0, WHD862CHC1, WHD862CHC2, YWED99HEDC0, YWED7990FW0, YWED9290FC0, YWED9290FW0
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
