WATER LEAKING FROM THE WASHER DOOR AREA
Whirlpool Washer Door Bellow W11173364, Fixes Water leaking from the washer door area
Door boot seal/bellow that forms a seal between the wash tub and door to help prevent leaks.
Part W11173364Replaces W10900509, WPW10474364, W10474364Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW11173364
ReplacesW10900509, WPW10474364, W10474364
ManufacturerWhirlpool
Appliance TypeWasher
Part TypeWasher Door Bellow
✅ Cross Reference Information
Current Part NumberW11173364
ReplacesW10900509, WPW10474364, W10474364
Common Symptoms
- Visible tears, cracks, or punctures in the rubber boot
- Mildew, residue buildup, or persistent odor on the seal
- Door does not close or lock correctly because the boot is damaged or misaligned
- Water collecting in the bottom fold because the boot’s drain openings are obstructed or incorrectly positioned
Check Before Replacing
- Disconnect electrical power before inspection.
- With the washer empty, visually inspect the entire accessible boot for tears, cracks, punctures, deformation, trapped objects, or separation from its seating surfaces.
- Check whether the leak originates at the door boot rather than another nearby component before replacing the seal.
- Inspect the bottom drain openings in the boot for visible residue or obstruction and confirm they are positioned at the bottom.
- Verify that the boot is not folded into the door-closing path or visibly misaligned.
Pro Tip
Keep the door slightly open between cycles and periodically remove visible residue from the boot folds to help reduce odor and mildew buildup.
Part Details
Part NumberW11173364
Part TypeWasher Door Bellow
ManufacturerWhirlpool
Appliance TypeWasher
Primary FunctionFlexible door boot seal/bellow that seals the gap between the washer door and wash tub, helping contain water during wash cycles.
Installation Notes
- Disconnect electrical power before installation; shutting off the washer’s water supplies is also recommended.
- Replacement requires access to the boot mounting area and some washer disassembly; exact access steps vary by model.
- The boot is retained by mounting rings or clamps; preserve and correctly reseat the applicable retainers during installation.
- Clean visible residue and debris from the sealing surfaces before fitting the replacement.
- Align the boot correctly, including its lower drain openings, before reassembly.
- Confirm the door closes and latches normally, then check for leaks during a controlled test cycle.
Verified Compatible Models
7MWFW94HEBU0, BNQ11DCANA0, MHW7000AG0, MHW7000AG2, MHW7000AW0, MHW7000AW2, MHW7000XG2, MHW7000XR2, MHW7000XW2, WFL98HEBU0, WFW92HEFBD0, WFW92HEFC0, WFW92HEFU0, WFW92HEFW0, WFW97HEXL2, WFW97HEXL3, WFW97HEXR2, WFW97HEXR3, WFW97HEXW2, WFW97HEXW3, WFW9290FBD0, WFW9290FC0, WFW9290FW0
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
