Whirlpool Washer control board W11188527, Replaces W10850396

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Washer will not start
• Washer stops mid-cycle
• Washer will not fill properly
• Washer will not drain
• Washer will not spin or agitate
• Lid will not lock or unlock reliably

Check Before Replacing

• Confirm the washer has power and that the outlet and circuit breaker are functioning before suspecting the control board.
• Unplug the washer, then inspect the control-board wiring harnesses and connectors for looseness, damage, corrosion, or visible overheating; reconnect only connectors that are clearly loose and accessible.
• Use the appliance’s model-specific service-diagnostic cycle, when available, and record stored fault codes before replacing the board.
• With power disconnected, inspect the board for visible burn marks or other physical damage. A damaged board should be replaced, but similar symptoms can also originate from wiring, valves, pumps, locks, or other components.

Pro Tip

Part Details

Installation Notes

• Disconnect electrical power and unplug the washer before accessing or replacing the control board.
• Follow the model-specific service literature and the replacement board’s included instructions; connector locations and access steps can vary by washer model.
• Document connector positions before removal and ensure every connector is fully seated during reassembly.
• After installation, restore power and run the washer’s model-specific service-diagnostic or verification cycle, if provided.

Verified Compatible Models

11027022710, CAE2745FQ0, CAE2765FQ0, CAE2795FQ0, MAT20CSAWW0, MAT20MNAWW0, QCAE2735FQ0

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.