WASHER WILL NOT START OR RESPOND NORMALLY
Whirlpool Washer Electronic control board W11201288, Fixes Washer will not start or respond normally
Genuine Whirlpool OEM electronic control board for washers. It manages washer functions including filling, washing, draining, spinning, cycle timing, temperature, and water levels.
Part W11201288Replaces W11033859, W11051516, W11195089Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW11201288
ReplacesW11033859, W11051516, W11195089
ManufacturerWhirlpool
Appliance TypeWasher
Part TypeElectronic control board
✅ Cross Reference Information
Current Part NumberW11201288
ReplacesW11033859, W11051516, W11195089
Common Symptoms
- Washer does not start or power up normally
- Control-panel buttons or display are unresponsive
- Washer displays control-related error codes
- Wash cycles run unusually long or short
Check Before Replacing
- Confirm the washer is receiving power and that the household circuit has not tripped.
- With the washer unplugged, visually inspect the control-board wiring harnesses and connectors for loose, damaged, or corroded connections.
- Use the washer’s model-specific service-diagnostic cycle and technical sheet to check for stored error codes and control-related failures.
- Before condemning the board, verify that the symptom is not caused by a door-lock, drain-pump, inlet-valve, wiring, or other connected component.
Pro Tip
A control-board symptom is not conclusive by itself; verify power, connectors, stored diagnostic codes, and related components before replacing the board.
Part Details
Part NumberW11201288
Part TypeElectronic control board
ManufacturerWhirlpool
Appliance TypeWasher
Primary FunctionControls and coordinates washer operations, including filling, washing, draining, spinning, cycle timing, temperature, and water-level management.
Installation Notes
- Disconnect electrical power before installation.
- Use the exact washer model and serial number to confirm application before ordering or installing.
- With power disconnected, transfer connectors carefully and ensure each harness is fully seated in its original location.
- Wear appropriate hand protection and follow the model-specific service documentation supplied for the washer or replacement part.
- After installation, restore power and run the applicable model-specific diagnostic or functional test.
Verified Compatible Models
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
All brand names are the property of their respective owners and are used for compatibility reference only.
