Whirlpool Washer Fan / Vent Fan Enclosure Assembly W11316273, Replaces W10919156, W11482448 – Superseded by W11752586

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Vent fan does not activate when commanded.
• F4E4 Vent Fan Motor Fault may be displayed on applicable models when an open or short circuit is detected.

Check Before Replacing

• Check the rear vent for an obstruction that could prevent the fan from spinning.
• Where the model supports it, run the washer’s Component Activation Test to command the vent fan.
• With power disconnected, visually confirm the fan harness connection and ACU connector J12 are fully seated.
• For qualified service personnel: with power disconnected, test fan-terminal resistance; the service manual specifies 1.78–2.3 kΩ. An out-of-range or open reading does not by itself rule out harness or control issues.

Pro Tip

Part Details

Installation Notes

• Disconnect power before servicing; replace all panels before operating.
• The Whirlpool service procedure for the DVT fan/vent assembly calls for turning off the water supply, disconnecting the inlet and drain hoses, and removing the top panel before access.
• Disconnect the tub hose and fan connector, remove the two T20 Torx screws securing the DVT enclosure to the rear bracket, then lift the enclosure to disengage its tabs. Reinstall in reverse order.
• Because the service literature is intended for trained technicians, use a qualified appliance technician if electrical testing or cabinet disassembly is not appropriate for you.

Verified Compatible Models

8TWFW8620HW0, 8TWFW8620HW1, BNF15ASANA0, MHW6630HW0

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.