Whirlpool Dryer Not Starting, Showing Error Codes, or Behaving Erratically? Control Board W11351728 – Fix Electronics Fast

When your Whirlpool dryer won't start, displays persistent error codes, runs erratically, or loses control of heat and cycle timing, the electronic control board is the most likely cause. In most Whirlpool-built electric and gas dryers, the control board is the central processing unit that manages every dryer function — motor start, heat relay, cycle timing, sensor inputs, and user interface — when it fails, the dryer may refuse to start, run partial cycles, display fault codes, or behave unpredictably. ⚡ Common failure point in Whirlpool-built dryers after power surges or component failures. Part W11351728 is the genuine OEM replacement control board, superseding W11296385, W11314472, and W11321064, that restores full electronic control and normal dryer operation.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your dryer powers on — display lights up or responds to button presses
• ✔ Basic components (door switch, thermal fuse, motor) have been tested and confirmed good
• ✔ Power supply is confirmed OK — correct voltage at the outlet, no tripped breakers
• ✔ The issue is not a single component failure (e.g. heating element, thermistor) that has already been ruled out
• ✔ ONLY problem is no start, persistent error codes, erratic cycling, or loss of heat/timing control

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Dryer won't start — buttons unresponsive or cycle won't initiate
• Persistent error or fault codes on the display that won't clear
• Dryer starts but stops mid-cycle without completing
• Heat not cycling correctly — runs too hot, too cold, or not at all
• Cycle timer not advancing — dryer runs indefinitely or stops too early
• Control panel buttons work intermittently or not at all

✔ If these symptoms match after ruling out individual component failures, the control board is the most likely cause.

✔ In most cases, replacing this control board restores full dryer operation immediately.

📦 Part Details

• Part Number: W11351728
• Type: Dryer Electronic Control Board (main PCB)
• Replaces: OEM direct-fit control board — supersedes W11296385, W11314472, W11321064 (no modification required)
• Brands: Whirlpool, Maytag, Amana, KitchenAid, Kenmore

⚙️ Installation

Skill Level: Moderate — 30–45 minutes. Disconnect power at the breaker or unplug the dryer before beginning. Access to the control board typically requires removing the top panel and control console — photograph all wire harness connections before disconnecting. Transfer connectors one at a time to the new board to avoid mis-wiring, then reassemble in reverse order. Restore power and run a test cycle to confirm all functions operate correctly.

✓ Compatible Models

Confirmed compatible with select Whirlpool, Maytag, Amana, KitchenAid, and Kenmore dryer models. Contact us to verify your model number before ordering.

🔗 Model Hub Pages

No model-specific hub pages linked yet — contact us with your model number and we'll point you to the right parts breakdown.

💡 Pro Tip