Whirlpool Washer Tub-to-Pump Hose W11366249

Genuine Whirlpool OEM tub-to-pump hose that carries water from the washer tub to the drain pump. It may also be used in washer/dryer combo and commercial laundry-center applications.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Washer powers on and cycles start normally
• ✔ Drain pump motor runs (audible hum during drain cycle)
• ✔ Drain hose at the back of the machine is clear and unkinked
• ✔ No error codes pointing to pump motor failure
• ✔ ONLY problem is water leaking under the machine or washer not draining despite pump running

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Water leaking from under the washer during or after a cycle — most common customer complaint
• Washer won’t drain or drains very slowly
• Water pooling inside the washer cabinet at the base
• Visible cracks, splits, or soft spots on the existing hose
• Hose found disconnected or loose from the pump inlet
• F9E1 or drain-related error codes on display

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this tub-to-pump hose restores normal drainage immediately.

✅ Cross Reference Information

Part Details

• Part Number: W11366249
• Part Type: Tub-to-Pump Hose
• Manufacturer: Whirlpool
• Appliance Type: Washer

⚙️ Installation

Skill Level: MODERATE — 20–40 minutes. Disconnect power and water supply before beginning. Access the hose by removing the front lower panel or tilting the machine back depending on model. Release the spring clamps at each end, slide the old hose off, and seat the new hose fully before repositioning the clamps. Run a short drain cycle to confirm no leaks before reassembling the panel.

Verified Compatible Models

💡 Pro Tip

✓ Model-Specific Repair Pages