DRYER CONTROLS ARE UNRESPONSIVE OR THE CYCLE DOES NOT START, STOP, OR OPERATE CORRECTLY
Whirlpool Dryer Electronic Control Board W11388040, Fixes Dryer controls are unresponsive or the cycle does not start, stop, or operate correctly
Genuine Whirlpool programmed electronic control board (listed as “CNTRL-ELEC” / “PROG ACU JANUS, 5620, ELE”) for a dryer. It manages dryer functions including drying time and temperature.
Part W11388040Replaces W11314904, W11364932, W11385395Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW11388040
ReplacesW11314904, W11364932, W11385395
ManufacturerWhirlpool
Appliance TypeDryer
Part TypeDryer Electronic Control Board
✅ Cross Reference Information
Current Part NumberW11388040
ReplacesW11314904, W11364932, W11385395
Common Symptoms
- Dryer will not start
- Dryer starts and stops unexpectedly
- Dryer will not stop
- Dryer controls or buttons do not respond
- Dryer drum does not turn
- Dryer does not heat or takes too long to dry
Check Before Replacing
- Confirm the dryer has power and that the household breaker or fuse is not tripped.
- Check that the door switch and user controls operate normally before condemning the control board.
- With power disconnected, inspect the board and its connectors for loose connections, corrosion, damaged wiring, burn marks, or visibly shorted components.
- Use the appliance-specific service diagnostic procedure, if available, to check stored fault information and control operation.
- Do not replace the board solely from a generic symptom; other components can produce similar dryer problems.
Pro Tip
Because control-board failures can be misdiagnosed, check power, the door switch, user controls, wiring, and other commonly failed components first; the board is not easily tested by a simple standalone check.
Part Details
Part NumberW11388040
Part TypeDryer Electronic Control Board
ManufacturerWhirlpool
Appliance TypeDryer
Primary FunctionControls programmed dryer operation, including cycle timing, temperature control, and operation of connected dryer functions.
Installation Notes
- Disconnect electrical power before servicing or handling the control board.
- Verify the replacement board matches the dryer's complete model and serial information before installation.
- Transfer connectors carefully and ensure each harness is fully seated in the corresponding location.
- Inspect connectors and wiring for damage or corrosion while the board is accessible.
- After installation, restore power and verify basic control response and dryer operation using the appliance-specific service or diagnostic procedure.
Verified Compatible Models
7MWED5620HW1, 8TWED5620HW0, WED5620HW1, YWED5620HW1
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
All brand names are the property of their respective owners and are used for compatibility reference only.
- Choosing a selection results in a full page refresh.
