Dishwasher Not Starting or Running Erratic Cycles – Fix Your Control Board Fast
If your dishwasher won't start, stops mid-cycle, or displays error codes with no response, the control board is the most likely culprit. In Whirlpool and KitchenAid dishwashers, a failed control board causes the unit to lose communication with all wash, drain, and sensor functions — leaving dishes dirty and the machine dead. ⚡ Don't wait — a failed board won't self-correct and can cascade into door latch and pump failures. Part W11410062 is the genuine OEM replacement that restores full electronic control and normal wash cycle operation immediately.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your dishwasher model is KDPM604KBS0, KDPM604KPS0, KDTM604KBS0, or KDTM604KPS0
- ✔ The dishwasher does not start or stops mid-cycle
- ✔ Control panel buttons are unresponsive or display error codes
- ✔ Power is confirmed at the outlet and door latch is functioning
- ✔ ONLY problem is loss of electronic control / erratic cycle behaviour
🔧 Common Symptoms
- Dishwasher will not start when cycle is selected
- Cycle stops randomly mid-wash or mid-drain
- Control panel lights flash or display fault codes (F codes / E codes)
- Buttons on the control panel are completely unresponsive
- Dishwasher runs but does not heat, spray, or drain correctly
- Unit powers on but immediately shuts off with no action
✔ If these symptoms match, the control board is the most likely failed component in the system.
✔ In most cases, replacing this control board restores normal operation immediately.
📦 Part Details
- Part Number: W11410062
- Type: Dishwasher Electronic Control Board
- Replaces: W11348063 (no modification required)
- Brands: Whirlpool, KitchenAid
⚙️ Installation Notes
Skill Level: MODERATE — 30–45 minutes. Disconnect power at the breaker before beginning. Remove the inner door panel to access the control board housing, disconnect all wire harness connectors (photograph before removal), swap the board, and reconnect in reverse order. Ensure all harness clips are fully seated — a loose connector will cause the same symptoms as a failed board.
💡 Pro Tip
Before replacing the control board, confirm the door latch microswitch is sending a signal — a faulty latch can mimic a dead control board. If the latch checks out and the board still won't respond, W11410062 is your fix. While the door panel is open, inspect the wire harness for heat damage or corrosion and replace if needed to avoid a repeat failure.
✓ Compatible Models
Confirmed compatible with KDPM604KBS0, KDPM604KPS0, KDTM604KBS0, KDTM604KPS0. Contact us to verify your model number before ordering.
KDPM604KBS0, KDPM604KPS0, KDTM604KBS0, KDTM604KPS0
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
