Whirlpool Dishwasher Electronic Control Board (CNTRL-ELEC) W11410062, Replaces W11348063

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Dishwasher does not start despite confirmed power and a latched door.
• Dishwasher stops during a wash, drain, or drying cycle.
• Control-panel buttons or display do not respond normally.
• Dishwasher displays fault indications while cycle control is impaired.
• Washing, draining, or drying functions operate inconsistently.

Check Before Replacing

• Confirm the dishwasher circuit breaker or fuse has not tripped.
• Verify the door closes fully and the latch engages.
• Check that Control Lock is not enabled.
• Inspect accessible control-board wire-harness connections for looseness, corrosion, or heat damage with power disconnected.
• Use the appliance-specific service diagnostics procedure and wiring information before condemning the control board.
• Do not diagnose the board solely from a no-start symptom; power-supply, door-latch, user-interface, wiring, and load-component faults can produce similar symptoms.

Pro Tip

Part Details

Installation Notes

• Disconnect electrical power at the breaker or service disconnect before accessing or replacing the board.
• Follow the model-specific service information and observe electronic-component handling precautions.
• Document connector locations before removal and make sure each harness is fully seated during reassembly.
• Confirm the replacement board matches the appliance model and existing part identification before installation.

Verified Compatible Models

Fitment reminder: Verified compatibility is maintained by the XPart Model Hub Network. Match the complete appliance model number before ordering.