Whirlpool Washer Dispenser Housing / Dispenser Housing and Inlet Valve Assembly W11413407, Replaces W11094592

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Detergent remains in the bulk dispenser drawer after a cycle.
• Little or no water enters the dispenser during filling.
• Uneven or incomplete detergent dispensing caused by restricted water flow through the housing.
• Water leakage around the dispenser housing or integrated inlet-valve connections.
• Washer may have fill-related symptoms when the integrated inlet valve does not open, although other supply, control, or wiring faults can cause similar symptoms.

Check Before Replacing

• Confirm the washer’s household water supply valves are fully open and the inlet hoses are not kinked.
• With the washer disconnected from power, inspect the bulk dispenser drawer and housing for detergent buildup or visibly blocked water passages; clean only according to the washer’s owner or service instructions.
• Observe whether water enters the dispenser during a normal fill cycle, without bypassing safety devices or disassembling energized components.
• Inspect the housing, hose connections, and surrounding cabinet area for visible leaks after a cycle; stop use if water is leaking.
• Verify that the dispenser drawer is seated correctly and that the washer model’s parts diagram identifies W11413407 as the applicable assembly.
• If electrical testing is required, use the model-specific service documentation or a qualified technician; do not assume a no-fill symptom proves this assembly is defective.

Pro Tip

Part Details

Installation Notes

• Disconnect electrical power and turn off the washer’s water supply before servicing.
• Confirm the complete washer model number and parts diagram before ordering or installing; the assembly is not universally interchangeable across Whirlpool washers.
• Follow the model-specific service procedure for removing panels, hoses, electrical connectors, and the dispenser assembly.
• When transferring connections, match each hose and electrical connector to its original location and inspect seals and hose ends for damage.
• After installation, restore water and power, run an appropriate test or fill cycle, and check the dispenser and all connections for leaks before returning the washer to normal use.

Verified Compatible Models

7MWTW8127LW0, WTW6120HC0, WTW6120HC1, WTW6120HC2, WTW6120HW0, WTW6120HW1, WTW6120HW2, WTW7120HC0, WTW7120HW0, WTW8120HC0, WTW8120HW0, WTW8127LC0, WTW8127LW0

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.