WASHER WILL NOT POWER UP, WITH NO DISPLAY OR KEYPAD RESPONSE
Whirlpool Corporation Washer machine-and-motor control board (electronic control board / ACU assembly) W11419171, Fixes Washer will not power up, with no display or keypad response
Genuine Whirlpool-manufactured control board used in select Maytag and Whirlpool top-load washers. The board manages washer operating functions and is documented as a replacement for W11266006.
Part W11419171Replaces W11266006Whirlpool Corporation
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW11419171
ReplacesW11266006
ManufacturerWhirlpool Corporation
Appliance TypeWasher
Part TypeWasher machine-and-motor control board (electronic control board / ACU assembly)
✅ Cross Reference Information
Current Part NumberW11419171
ReplacesW11266006
Common Symptoms
- Diagnostic LED on the main control is off or steadily on rather than flashing.
- F6E1 communication fault indicating the HMI cannot hear the ACU.
- A no-power/no-response condition remains after the outlet, power cord, and ACU-to-HMI connections have been checked.
Check Before Replacing
- Check Fault History in the washer’s Service Mode before replacing parts.
- Observe the main-control diagnostic LED: flashing indicates correct incoming line voltage and a functioning processor; LED off or on calls for the model-specific Main Control (ACU) test.
- Before condemning the control, check power at the outlet/circuit protection, power-cord continuity, and connections between the main control and HMI.
- Use the washer’s model-specific Service Diagnostics and component-activation tests to distinguish an ACU issue from connected components, wiring, or the user interface.
Pro Tip
On the covered platform, perform the required calibration after replacing the main control; the official tech sheet states that calibration is required after main-control replacement and warns that skipping it can cause poor wash performance.
Part Details
Part NumberW11419171
Part TypeWasher machine-and-motor control board (electronic control board / ACU assembly)
ManufacturerWhirlpool Corporation
Appliance TypeWasher
Primary FunctionActs as the washer’s main ACU (machine-and-motor control), receiving system inputs and controlling/monitoring washer operation through the model’s service diagnostics.
Installation Notes
- Disconnect electrical power before accessing or replacing the control board.
- Follow the exact washer model’s technical sheet/service procedure rather than using board symptoms alone as a diagnosis.
- After replacement, reassemble panels, restore power, perform the required calibration where applicable, and run Service Diagnostics to verify the repair.
Verified Compatible Models
7MMVW7230LC0, 7MMVW7230LW0, MVW7230HC0, MVW7230HW0, MVW7232HC0, MVW7232HW0
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
