Refrigerator Not Dispensing Water or Making Ice? Water Valve W11482025 – Fix It Fast

No water from the dispenser and no ice production are the two most common signs of a failed refrigerator water inlet valve. In most Whirlpool and KitchenAid refrigerators, this is caused by a failed water valve solenoid that can no longer open under normal line pressure. When it fails, water flow to the ice maker and dispenser is cut off entirely — even if the water line and filter are clear. ⚡ Common failure point in Whirlpool-built French door and side-by-side refrigerators. Part W11482025 is the genuine OEM replacement that restores full water and ice function immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Your refrigerator powers on and runs normally — cooling is not affected
• ✔ The ice maker is not producing ice, or production has stopped completely
• ✔ The water dispenser produces no water or only a trickle
• ✔ The water supply line is connected, not kinked, and the shut-off valve is open
• ✔ ONLY problem is no water / no ice — not a filter, line, or pressure issue

Not sure? Send us your model number — we’ll confirm before you order.

🔧 Common Symptoms

• Refrigerator not dispensing water — dispenser lever activates but nothing comes out
• Ice maker stopped making ice completely
• Ice maker fills very slowly or produces undersized cubes
• Humming or buzzing sound from the back of the fridge when dispenser is pressed
• Water dispenser works intermittently — sometimes flows, sometimes doesn’t
• Visible water leak at the valve connection point at the rear of the unit

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this water valve restores normal operation immediately.

📦 Part Details

• Part Number: W11482025
• Type: Refrigerator Water Inlet Valve (dual solenoid)
• Replaces: OEM direct-fit water valve assembly — supersedes W11460084, W10865826, WPW10238100 (no modification required)
• Brands: Whirlpool, KitchenAid, Maytag

⚙️ Installation

Skill Level: Moderate — 20–30 minutes. Unplug the refrigerator and shut off the water supply before beginning. Pull the unit away from the wall to access the valve at the lower rear. Disconnect the water line and wiring harness, remove the two mounting screws, and swap in the new valve. Reconnect wiring and water line, restore power and water supply, then run 2–3 dispenser cycles to purge air before checking for leaks. Do not overtighten the water line fitting — hand-tight plus a quarter turn is sufficient.

💡 Pro Tip

Model Hub Pages:
KRFF507HBS02, KRFF507HPS02, KRFF507HWH02, KRMF706EBS04, KRMF706ESS04, MFT2772HEZ02, WRF757SDHV02, WRF757SDHZ02, WRF767SDHV02, WRF767SDHZ02, WRX986SIHV02, WRX986SIHZ02

✓ Model-Specific Repair Pages