Whirlpool Top-Load Washer Electronic Control Board W11498190 – OEM Replacement (Replaces W11211478, W11256099, W11476577)

The electronic control board is the brain of your Whirlpool top-load washer — it manages every electronic function including cycle selection, water level control, motor speed and direction, drain pump operation, water inlet valve control, lid lock engagement, and user interface communication. When the board fails from a power surge, moisture intrusion, or component burnout, the washer refuses to start, stops mid-cycle without completing, displays error codes that won’t clear after a reset, or goes completely dead with no lights or response. The W11498190 is the OEM main electronic control board (PCB assembly) for Whirlpool, Maytag, Amana, and Inglis top-load washers, superseding W11211478, W11256099, and W11476577. Available in OEM New and OEM Used (tested pull) conditions.

⚠️ Symptoms This Part Fixes

• Washer won’t start or respond when the start button is pressed
• Washer won’t fill with water despite water supply being on
• Washer won’t drain or spin at the end of a cycle
• Washer stops mid-cycle and won’t resume
• Error codes displayed that won’t clear after a reset or power cycle
• Control panel completely dead — no lights, no display, no response
• Washer cycles erratically or skips cycle stages
• Lid lock not engaging or disengaging correctly

✓ Part Details

• OEM Part Number: W11498190
• Replaces: W11211478, W11256099, W11476577
• Type: Main electronic control board (PCB assembly)
• Compatible Brands: Whirlpool, Maytag, Amana, Inglis
• Application: Top-load washing machines
• Available Conditions: OEM New and OEM Used (tested pull)
• Ships From: Canada

⚙️ Installation Notes

Skill Level: Intermediate — 30–45 minute repair. Unplug the washer before beginning. The control board is located in the control console at the top rear of the washer. Release the console clips or screws at the rear or underside of the panel to access the board. Photograph all wire harness connections before disconnecting — connector positions vary by model. Press release tabs to disconnect harness connectors; never pull on the wires. Transfer any standoffs or brackets from the old board to the new W11498190. After installation, if error codes persist, perform a hard reset by unplugging the washer for 60 seconds before running a test cycle.

✓ Compatible Models

Fits Whirlpool, Maytag, Amana, and Inglis top-load washing machines including: ITW4880HW1, ITW4880HW2, NTW4519JW0, NTW4519JW1, WTW4655JW0, WTW4655JW1, WTW4850HW1, WTW4850HW2, WTW4855HW1, WTW4855HW2, WTW4855HW3, WTW5000DW3, WTW5005KW0, MVWC565FW2, MVWX655DW2, CAW42114GW2, 7MMVWC565FW1. Don’t see your model? Contact us and we’ll confirm compatibility before you order.

✓ Model-Specific Repair Pages