Whirlpool Washer Main Electronic Control Board W11513246, Replaces W11428994

Is This the Right Part?

✅ Cross Reference Information

Common Symptoms

• Blank or intermittent control panel
• Cycle stops or fails to advance
• Washer will not drain or spin
• Washer does not fill properly
• Unpredictable fill, wash, drain, or spin operation
• Persistent control-related error codes

Check Before Replacing

• Verify the washer has the correct incoming power before identifying the control board as faulty.
• Inspect the board and accessible wiring connectors for visible burn marks, damage, looseness, or corrosion with power disconnected.
• Check the lid-lock assembly and wiring connections because a lid-lock fault can prevent normal cycling.
• Run the washer’s model-specific service diagnostic cycle when available and compare the results with the applicable technical sheet.
• Compare the installed board’s part number and connector arrangement with the replacement before ordering.

Pro Tip

Part Details

Installation Notes

• Disconnect electrical power before servicing the washer.
• Handle the electronic board by its edges and protect it from static discharge.
• Photograph or label wiring locations before disconnecting connectors, then match the replacement board’s connector layout.
• After installation, run the applicable model-specific calibration or diagnostic cycle when required by the service documentation.
• Use the washer’s model-specific service information if programming, calibration, or diagnostic procedures are required.

Verified Compatible Models

CAW45125LW0, WTW5010LW0, WTW5015LW0, WTW5057LW0

Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.