Whirlpool Dryer Drum Roller Support Assembly W11519506 – Fix Squeaking, Thumping, or Grinding Drum Noise | OEM
The drum roller supports the full weight of the dryer drum and allows it to spin smoothly and quietly on every cycle. When the roller wears flat, cracks, or seizes on its shaft, the drum starts to wobble and drag — producing the squeaking, thumping, or grinding noise that gets louder with every load. The W11519506 Whirlpool OEM Drum Roller Support Assembly is the factory-specified replacement that restores smooth, quiet drum rotation and stops the noise at its source.
Whirlpool Dryer Dryer Drum Roller W11519506
Is This the Right Part?
Confirm the complete model number before ordering. Similar parts may use different connectors, dimensions, hose positions, electrical ratings, or mounting points.
- Loud squeaking or squealing that starts when the dryer begins tumbling
- Rhythmic thumping noise that repeats with every drum rotation
- Grinding or scraping sound from inside the dryer cabinet
- Drum wobbling or not rotating smoothly
- Excessive vibration during the cycle
- Drum dragging, slowing, or stopping mid-cycle
- Noise that worsens progressively with each load
- OEM Part Number: W11519506
- Brand: Whirlpool OEM
- Component: Drum roller support assembly (roller wheel, shaft, and mounting bracket)
- Includes: Complete assembly — roller wheel, shaft, and mounting bracket
- Appliance Type: Electric and gas dryer
- Compatible Brands: Whirlpool, Maytag, KitchenAid, Amana, Kenmore
- Genuine OEM: Yes — factory-specified replacement
- Skill Level: Intermediate — requires front panel removal and drum removal
- Estimated Time: 45–75 minutes
- Key Steps: Unplug dryer → Remove lint screen and top panel screws → Lift top panel and remove front panel screws → Support drum and disconnect drive belt → Remove drum to access rear bulkhead rollers → Remove retaining clip and pull old roller off shaft → Install new roller assembly and secure retaining clip → Reinstall drum, route belt over idler pulley and motor pulley → Reassemble front and top panels → Restore power and run a test cycle
- Safety: Always unplug the dryer before beginning. Never reach into the cabinet with power connected. Confirm the belt is correctly routed before reassembling — an incorrectly routed belt will cause the drum to not spin or the belt to snap immediately.
- Canadian Business Since 1996 — 30 Years of Appliance Parts Expertise
- Guaranteed Fit — OEM parts matched to your exact model
- Fast Canada-Wide Shipping
- Trusted by DIYers and Appliance Technicians Across Canada
- Expert support to confirm compatibility before you order
Most dryers have two rear drum rollers (and sometimes two front rollers) that wear at the same rate. If one roller has failed, the others are close behind. Replace all rollers in one visit — the labour is already done. While the drum is out, inspect the drive belt for fraying or cracking and spin the idler pulley by hand to check for roughness or wobble. Replacing worn companion parts now prevents a second disassembly within months and is the standard practice for any professional dryer repair.
Part Details
Use a qualified technician when diagnosis or installation is outside your experience. Gas parts should be installed by a licensed technician.
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
