Dishwasher Door Leaking or Inner Panel Cracked? Inner Door W11559689 – Fix Door Seal Failures Fast

When your dishwasher leaks from the door, the inner panel is cracked or warped, or the door won't close and seal evenly, the inner door panel is the structural component that needs replacing. In KitchenAid and Maytag dishwashers, the inner door panel forms the wash-side face of the door assembly, providing the rigid backing that holds the gasket channel, latch mechanism, and door insulation in alignment. When it cracks or warps, water escapes the wash cavity during cycles, steam leaks during drying, and the door may no longer close flush against the tub. ⚡ Common failure point in KitchenAid and Maytag dishwashers — especially after impact or long-term thermal stress. Part W11559689 is the genuine OEM replacement that restores a watertight door seal, proper latch engagement, and full structural integrity to the door assembly.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Dishwasher operates normally — wash, drain, and controls all function correctly
• ✔ The door gasket/seal is intact — not cracked, compressed, or missing
• ✔ The outer door panel and handle are undamaged
• ✔ ONLY problem is a cracked, warped, or structurally compromised inner door panel causing leaks or poor door closure

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Water leaking from the dishwasher door during wash or rinse cycles
• Inner door panel visibly cracked, warped, or broken
• Door not closing flush or latch not engaging cleanly
• Steam escaping from the door perimeter during the drying cycle

✔ If these symptoms match, this is the most likely failed component in the system.

✔ In most cases, replacing this inner door panel eliminates leaks and restores proper door closure immediately.

📦 Part Details

• Part Number: W11559689
• Type: Dishwasher Inner Door Panel Assembly (Item #10 in diagram)
• Replaces: W11098822, W11393130
• Brands: KitchenAid, Maytag
• Condition: New OEM — Clearance Price

⚙️ Installation

Skill Level: MODERATE — 30–60 minutes. Disconnect power before servicing. Open the dishwasher door fully and remove the outer door panel screws along the perimeter to separate the inner and outer panels. Transfer all components — latch assembly, wiring harness, and insulation — from the old inner door to the new one. Reassemble in reverse order, restore power, and run a full cycle to confirm no leaks.

✓ Compatible Models

Confirmed compatible with KDFE104KBL0, KDFE104KPS0, KDFE104KWH0, KDFE204KBL0, KDFE204KBS0, KDFE204KPS0, KDFE204KWH0, KDFM404KBS0, KDFM404KPS0, KDPM604KBS0, KDPM604KPS0, KDPM704KPS0, KDPM804KBS0, KDPM804KPS0, KDTE104KPS0, KDTE204KBL0, KDTE204KBS0, KDTE204KPS0, KDTE204KWH0, KDTM404KBS0, KDTM404KPS0, KDTM604KBS0, KDTM604KPS0, KDTM704KPS0, KDTM804KBS0, KDTM804KPS0, MDB8959SKB0, MDB8959SKK0, MDB8959SKW0, MDB8959SKZ0, MDB9959SKZ0, MDB9979SKZ0. Contact us to verify your model number before ordering.

✓ Model-Specific Repair Pages

💡 Pro Tip