Refrigerator Not Making Ice or Dispensing Water? Inlet Valve W11567408 – Fix No-Flow Fast

A failed water inlet valve is the most common cause of no ice production and no water dispenser output in Whirlpool-built refrigerators. In most Whirlpool, Maytag, and KitchenAid refrigerators, the water inlet valve is an electrically operated solenoid valve that controls water flow from the household supply line to the ice maker and water dispenser. When it fails — due to a burned solenoid coil, mineral scale buildup, or a cracked valve body — water stops flowing entirely, the ice maker goes dry, and the dispenser produces nothing. ⚡ One of the most common failure points in Whirlpool-platform refrigerators with ice and water dispensers. Part W11567408 is the genuine OEM replacement inlet valve that restores full water flow to the ice maker and dispenser immediately.

❓ Is This the Right Part?

This is the correct fix if ALL of the following are true:

• ✔ Refrigerator powers on and cools normally
• ✔ Household water supply line is connected, turned on, and pressure is confirmed adequate (min. 20 PSI)
• ✔ Water filter has been replaced recently and is not clogged or bypassed
• ✔ ONLY problem is no water from the dispenser or no ice production from the ice maker

Not sure? Send us your model number — we'll confirm before you order.

🔧 Common Symptoms

• Ice maker stops producing ice entirely
• Water dispenser produces no water or only a slow trickle
• Humming from the back of the fridge when dispenser is activated — valve energizes but won’t open
• Visible water leak at the valve body or inlet line connection

✔ If these symptoms match, this is the most likely failed component in the water supply system.

✔ In most cases, replacing this inlet valve restores full ice and water dispenser function immediately.

📦 Part Details

• Part Number: W11567408
• Type: Refrigerator Water Inlet Valve — dual-solenoid electrically operated valve controlling flow to ice maker and water dispenser
• Replaces: W11567408 (OEM direct replacement)
• Brands: Whirlpool, Maytag, KitchenAid, Amana

⚙️ Installation

Skill Level: Moderate — 20–30 minutes. Disconnect power and shut off the household water supply before servicing. Pull the refrigerator away from the wall and access the valve at the lower rear panel. Disconnect the water supply line, outlet tubes, and wiring harness from the old valve, transfer all connections to the new W11567408, and secure the valve to the mounting bracket. Restore water supply and power, then run the dispenser for 2–3 minutes to purge air and confirm full flow before pushing the unit back.

✓ Compatible Models

Confirmed compatible with Whirlpool, Maytag, and KitchenAid refrigerator models using the W11567408 water inlet valve. Contact us to verify your model number before ordering.

💡 Pro Tip

✓ Model-Specific Repair Pages