Refrigerator Not Cooling? Evaporator Motor W11575358 – Fix Fan Failure Fast
A failed evaporator fan motor is one of the most common causes of a refrigerator that won't cool properly or runs warm despite the compressor running. In KitchenAid and Whirlpool French-door refrigerators, the evaporator motor circulates cold air from the freezer section through the entire unit — when it fails, cooling stops and food spoilage follows fast. ⚡ Common failure point in KitchenAid-built French-door refrigerators. Part W11575358 is the genuine OEM replacement that restores proper airflow and full cooling performance without modification.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Your refrigerator powers on and the compressor runs normally
- ✔ The freezer section cools but the fridge compartment is warm
- ✔ You can hear the compressor running but no fan noise from the freezer
- ✔ Defrost system has been confirmed clear (no ice blockage on evaporator coils)
- ✔ ONLY problem is the evaporator fan motor — not the compressor, start relay, or control board
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Refrigerator compartment warm but freezer still cold
- No fan noise audible from behind the freezer back panel
- Refrigerator runs constantly but never reaches set temperature
- Food spoiling faster than normal despite correct temperature settings
- Frost buildup on freezer back wall (restricted airflow)
- Unusual grinding, rattling, or squealing from the freezer section
✔ If these symptoms match, the evaporator fan motor is the most likely failed component.
✔ In most cases, replacing this motor restores normal cooling immediately.
📦 Part Details
- Part Number: W11575358
- Type: Refrigerator Evaporator Fan Motor Assembly
- Replaces: OEM direct-fit motor assembly — supersedes W11402615 (no modification required)
- Brands: KitchenAid, Whirlpool
While the freezer back panel is off, inspect the evaporator coils for heavy frost or ice buildup — a blocked coil means your defrost heater or defrost thermostat may also need replacement. Addressing both at the same time prevents a repeat service call within weeks.
⚙️ Installation
Skill Level: Moderate — 30–45 min. Unplug the refrigerator before beginning. Remove all freezer contents and the freezer back panel (typically 4–6 screws) to access the evaporator assembly. Disconnect the motor wire harness, remove the mounting screws, and swap in the new motor. Reconnect the harness, reinstall the panel, and restore power. Confirm fan operation by listening for airflow within 60 seconds of startup.
💡 Pro Tip
After installing the new motor but before reinstalling the freezer back panel, plug the fridge in and confirm the fan spins freely and quietly. This saves you from pulling the panel a second time if a wire harness connector wasn't fully seated. Takes 60 seconds and eliminates the most common post-repair callback.
KRMF706EBS Series Repair Hub, KRMF706ESS Series Repair Hub
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
