DOOR DOES NOT SEAL FULLY
Whirlpool Refrigerator/freezer door gasket, gray (GASKET-FIP) W11625072, Fixes Door does not seal fully
Gray OEM snap-in door gasket that seals the perimeter of selected 36-inch refrigerator or freezer doors to prevent cold-air loss and warm-air entry.
Part W11625072Replaces W10760884, W10800788Whirlpool
Guaranteed to Fit — or your money back.
Confirm your full appliance model number before ordering.
Confirm your full appliance model number before ordering.
Is This the Right Part?
Part NumberW11625072
ReplacesW10760884, W10800788
ManufacturerWhirlpool
Appliance TypeRefrigerator
Part TypeRefrigerator/freezer door gasket, gray (GASKET-FIP)
✅ Cross Reference Information
Current Part NumberW11625072
ReplacesW10760884, W10800788
Common Symptoms
- Visible frost or condensation near the door perimeter
- Temperature fluctuation associated with air leakage at the door
- Door-ajar indication or switch contact problems when the gasket prevents the door from closing correctly
- Gasket appears dirty, warped, cracked, torn, or pulled out of its channel
Check Before Replacing
- Visually inspect the entire gasket perimeter for tears, gaps, deformation, or sections pulled out of the door channel.
- Check that the gasket-contacting cabinet surfaces are clean and free of food particles or debris.
- Close the door and inspect for visible gaps between the gasket and cabinet; do not force the door closed.
- Check whether shelves, bins, or food packages obstruct the door or prevent the gasket from contacting the cabinet.
- If available for the appliance, perform a gentle paper-strip check at several points around the closed gasket; resistance should be reasonably consistent. Do not use tools or excessive force.
- Confirm that the refrigerator is reasonably level, since leveling can affect door alignment and sealing.
Pro Tip
Before replacing the gasket, clean the gasket and mating cabinet surface, remove any door obstructions, and allow the replacement gasket to recover from packaging deformation according to the applicable appliance instructions; a new gasket may not seal correctly if the door is misaligned or blocked.
Part Details
Part NumberW11625072
Part TypeRefrigerator/freezer door gasket, gray (GASKET-FIP)
ManufacturerWhirlpool
Appliance TypeRefrigerator
Primary FunctionSeals the perimeter of the refrigerator/freezer door to limit cold-air escape and warm-air entry, helping maintain stable compartment temperature.
Installation Notes
- Verify the exact appliance model before installation; the gasket is for selected models only.
- Disconnect power before servicing if required by the appliance service instructions and keep hands clear of pinch points.
- Remove the old gasket and inspect the gasket channel and door edge for damage or debris before fitting the replacement.
- Seat the replacement gasket evenly into the door channel around the full perimeter; do not stretch, cut, glue, or otherwise modify it unless model-specific instructions explicitly require it.
- After installation, close the door gently and check the complete perimeter for uniform contact and gaps.
Verified Compatible Models
KBSD606ESS00, KBSD606ESS01, KBSD608EBS00, KBSD608EBS01, KBSD608ESS00, KBSD608ESS01, KBSD618ESS00, KBSD618ESS01, KBSD706MPS00, KBSD708MBS00, KBSD708MPS00, KBSD708MSS00, KBSN608EBS00, KBSN608EBS01, KBSN608EPA00
Fitment reminder: Match the complete appliance model number, including suffix or revision where applicable, before ordering.
Buy Online Pick Up In-Store
Address
101 Trillium Dr
Kitchener, Ontario N2E 1W8
Kitchener, Ontario N2E 1W8
Phone
Hours
Mon–Fri 9 AM–5 PM • Sat 9 AM–1 PM
