Washer not filling or filling slowly? In most Whirlpool, Maytag, and Kenmore washers, this is caused by a failed water inlet valve. When it fails, the washer won’t fill properly — causing stalled or incomplete cycles. ⚡ Common failure point in Whirlpool-built washers. Part W11641117 is the genuine OEM replacement that restores full hot and cold fill operation in one direct-fit swap.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ Washer powers on normally
- ✔ Drum spins and washer cycles start
- ✔ Drain pump works correctly
- ✔ Water supply valves are fully open
- ✔ ONLY problem is water not entering or filling properly
🔧 Common Symptoms
- Washer won’t fill — tub stays empty, cycle won’t start
- Fills very slowly — 10+ minutes for a normal fill level
- Humming or buzzing during fill with no water flowing
- F8E1 or LF error code on Whirlpool or Maytag washer
- Only hot or only cold water enters the tub
- Washer stuck on fill cycle, never advances
✔ If these symptoms match, this is the most likely failed component in the system.
✔ In most cases, replacing this valve restores normal fill operation immediately.
📦 Part Details
- Part Number: W11641117
- Type: Water Inlet Valve Assembly — dual solenoid (hot + cold)
- Replaces: OEM direct-fit water inlet valve assembly (no modification required)
- Brands: Whirlpool, Maytag, Kenmore
⚙️ Installation Notes
Skill Level: Moderate — 30–45 minutes. Unplug the washer and shut off both water supply valves before starting. Pull the unit away from the wall and remove the rear access panel. Disconnect the two inlet hoses (have a towel ready), unplug the solenoid wire harnesses, remove the mounting screws, and swap the valve. Reconnect hoses finger-tight then snug with pliers — do not overtorque or you’ll crack the valve body. Restore power and water slowly and check for leaks before pushing back into position.
✓ Compatible Models
Confirmed compatible with Whirlpool RTW4519PW0, 1CWTW4705GW2, 1CWTW4815EW3, 1CWTW4845EW3, 2DWTW4705EW3 and Kenmore 11020362813, plus additional Whirlpool, Maytag, and Kenmore washer models. Contact us to verify your model number before ordering.
💡 Pro Tip
Clogged inlet screens are often mistaken for a failed valve and can cause the same symptoms even after replacement. In hard water areas, install an inline hose filter to reduce mineral buildup and prevent repeat failures.
✓ Model-Specific Repair Pages
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
