Washer Not Dispensing Detergent? Dispenser Drawer W11752344 — Fix It Fast
If your Whirlpool washer is leaving detergent or fabric softener behind in the drawer, the dispenser drawer assembly is the most common cause. In most Whirlpool front-load washers, the dispenser drawer cracks, warps, or clogs over time — preventing detergent from flushing into the drum at the right cycle point. When it fails, clothes come out with detergent residue, fabric softener isn't released, or the drawer becomes difficult to open and close. ⚡ Common failure point in Whirlpool front-load washers. Part W11752344 is the genuine OEM replacement dispenser drawer that restores proper detergent and softener dispensing — eliminating residue and incomplete wash cycles.
❓ Is This the Right Part?
This is the correct fix if ALL of the following are true:
- ✔ QUALIFIER 1 — washer powers on and runs a full cycle
- ✔ QUALIFIER 2 — drum fills with water and spins normally
- ✔ QUALIFIER 3 — water supply and inlet valve are confirmed OK
- ✔ ONLY problem is detergent or softener remaining in the dispenser drawer after the cycle
Not sure? Send us your model number — we'll confirm before you order.
🔧 Common Symptoms
- Detergent left in the drawer after a completed wash cycle
- Fabric softener not dispensed — clothes have no softener scent
- Drawer is cracked, warped, or won't slide in and out smoothly
- Mold or buildup inside the drawer that can't be cleaned out
✔ If these symptoms match, this is the most likely failed component in the dispenser system.
✔ In most cases, replacing the dispenser drawer restores full detergent and softener dispensing immediately.
📦 Part Details
- Part Number: W11752344
- Type: OEM Washer Detergent & Fabric Softener Dispenser Drawer Assembly
- Appliance Type: Front-Load Washer
- Brands: Whirlpool
While the dispenser drawer is out, inspect the dispenser housing and the water inlet nozzles that flush the drawer. If the nozzles are clogged or the housing is cracked, clean or replace them at the same time — the drawer is already removed and it takes only a few extra minutes.
⚙️ Installation
Skill Level: EASY — 10–20 minutes. No tools required. Disconnect power before servicing. Pull the existing dispenser drawer fully out of the housing by pressing the release tab (usually located at the back of the drawer). Slide the new W11752344 drawer into the housing until it clicks into place. Run a rinse cycle to confirm detergent flushes correctly before running a full load.
✓ Compatible Models
Confirmed compatible with select Whirlpool front-load washer models. Contact us to verify your model number before ordering.
💡 Pro Tip
Before sliding in the new drawer, wipe out the dispenser housing cavity with a damp cloth and check that the flush nozzles are clear. Mold and detergent buildup in the housing can clog a brand-new drawer within weeks if left behind. A 5-minute clean now prevents the same problem from recurring.
✓ Shop by Appliance Type
✅Compatibility & Cross Reference
Not sure about your model number? Call 1-877-899-7278 and we’ll help you confirm. All brand names are the property of their respective owners and are used for compatibility reference only.
Buy Online Pick Up In-Store
Kitchener, Ontario N2E 1W8
- Choosing a selection results in a full page refresh.
