The WG01F07567 is the OEM GE dishwasher control board that manages all cycle timing, water usage, and electrical functions in your dishwasher. If your GE dishwasher won't start, is stuck mid-cycle, or is displaying error codes, the control board is the most common cause. This is a genuine OEM part that replaces WG01F07845, WD21X32060, 265D3162G073, and 265D4367G100. Note: this part has been superseded by WG02F16896 — see the banner above.

✓ Model-Specific Repair Pages

The WG01F07567 was the OEM board revision for a range of GE Profile and GE dishwasher models, superseding WG01F07845 and WD21X32060. It has since been replaced by WG02F16896 as the current OEM revision. The board controls all wash cycle logic, sensor inputs, motor and pump relay outputs, and the user interface.

✓ Common Symptoms Fixed

Dishwasher won't start or power on. Dishwasher stops mid-cycle or won't complete a cycle. Error codes displayed on control panel. Buttons or controls unresponsive. Dishwasher runs continuously without stopping. Water not filling or draining properly due to control failure. Lights flashing or blinking abnormally.

✓ Key Features & Specifications

Genuine OEM GE part — guaranteed fit and performance. Controls all cycle timing, sensor inputs, and pump relay functions. Superseded by WG02F16896 (current OEM). Replaces WG01F07845, WD21X32060, 265D3162G073, 265D4367G100. Compatible with GE Profile and GE dishwasher models including CDT845, GDT665, PDP715, PDT715, and PDT755 series. Weight: 10 lbs. Country of origin: Canada.

✓ Buying Options

OEM/New: Stock of WG01F07567 may be available. However, we recommend ordering WG02F16896 — the current OEM revision — for guaranteed fit and full lifespan.

✓ Replacement Part Numbers

WG02F16896 (current OEM — recommended), WG01F07567 (superseded), WG01F07845 (superseded), WD21X32060 (superseded), 265D3162G073 (superseded), 265D4367G100 (superseded)

✓ Installation Tips

Disconnect power to the dishwasher at the breaker before beginning any repair. The control board is typically located behind the inner door panel — remove the door screws and carefully separate the inner and outer door panels to access it. Photograph all wire harness connections before disconnecting. Reconnect all harnesses in the same positions, reassemble the door, and restore power to test. If error codes persist, perform a hard reset by cutting power for 60 seconds.

✓ Compatible Models

CDT845P2N8S1, CDT845P3N8D1, CDT845P4N8W2, GDT665SMN8ES, PDP715SYN8FS, PDT715SYN8FS, PDT755SYR8FS

✓ Frequently Asked Questions

Is WG01F07567 still available? Stock may be available, but WG01F07567 has been superseded by WG02F16896. We recommend ordering the current revision for guaranteed fit and full lifespan.

Will this board fit my GE Profile dishwasher? This board fits the CDT845, GDT665, PDP715, PDT715, and PDT755 series GE dishwashers. If your model is not listed, contact us for fit verification before ordering.

Can I install this myself? Yes — this is a DIY-friendly repair. Disconnect power, remove the inner door panel, swap the board, reconnect harnesses, and restore power. No soldering required.

Do you ship across Canada? Yes — XPart Supply ships Canada-wide with fast dispatch. Contact us for shipping timelines to your region.